N25Q128 - 1.8 V
Instructions
Figure 28. Sector Erase instruction sequence
S
C
0
1
2
3
4
5
6
7
8
9
29 30 31
Instruction
24 Bit Address
23 22
MSB
2
0
1
DQ0
Sect o r _Er ase
9.1.19
Bulk Erase (BE)
The Bulk Erase (BE) instruction sets all bits to '1' (FFh). Before it can be accepted, a Write
Enable (WREN) instruction must previously have been executed. After the Write Enable
(WREN) instruction has been decoded, the device sets the Write Enable Latch (WEL).
The Bulk Erase (BE) instruction is entered by driving Chip Select (S) Low, followed by the
instruction code on Serial Data input (DQ0). Chip Select (S) must be driven Low for the
entire duration of the sequence.
Chip Select (S) must be driven High after the eighth bit of the instruction code has been
latched in, otherwise the Bulk Erase instruction is not executed. As soon as Chip Select (S)
is driven High, the self-timed Bulk Erase cycle (whose duration is tBE) is initiated. While the
Bulk Erase cycle is in progress, the Status Register may be read to check the value of the
Write In Progress (WIP) bit. The Write In Progress (WIP) bit is 1 during the self-timed Bulk
Erase cycle, and is 0 when it is completed. At some unspecified time before the cycle is
completed, the Write Enable Latch (WEL) bit is reset.
The Bulk Erase (BE) instruction is executed only if all Block Protect (BP3, BP2, BP1, BP0)
bits are 0. The Bulk Erase (BE) instruction is ignored if one, or more, sectors are protected.
Figure 29. Bulk Erase instruction sequence
S
0
1
2
3
4
5
6
7
C
Instruction
DQ0
AI13743
99/185
MICRON [ MICRON TECHNOLOGY ]
