PIC18F2480/2580/4480/4580
REGISTER 18-4: SSPCON1: MSSP CONTROL REGISTER 1 (I2C™ MODE)
R/W-0
WCOL
R/W-0
R/W-0
SSPEN(1)
R/W-0
CKP
R/W-0
SSPM3(2)
R/W-0
SSPM2(2)
R/W-0
SSPM1(2)
R/W-0
SSPM0(2)
SSPOV
bit 7
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared x = Bit is unknown
bit 7
WCOL: Write Collision Detect bit
In Master Transmit mode:
1= A write to the SSPBUF register was attempted while the I2C conditions were not valid for a
transmission to be started (must be cleared in software)
0= No collision
In Slave Transmit mode:
1= The SSPBUF register is written while it is still transmitting the previous word (must be cleared in
software)
0= No collision
In Receive mode (Master or Slave modes):
This is a “don’t care” bit.
bit 6
SSPOV: Receive Overflow Indicator bit
In Receive mode:
1= A byte is received while the SSPBUF register is still holding the previous byte (must be cleared in
software)
0= No overflow
In Transmit mode:
This is a “don’t care” bit in Transmit mode.
bit 5
bit 4
SSPEN: Master Synchronous Serial Port Enable bit(1)
1= Enables the serial port and configures the SDA and SCL pins as the serial port pins
0= Disables serial port and configures these pins as I/O port pins
CKP: SCK Release Control bit
In Slave mode:
1= Releases clock
0= Holds clock low (clock stretch), used to ensure data setup time
In Master mode:
Unused in this mode.
bit 3-0
SSPM<3:0>: Master Synchronous Serial Port Mode Select bits(2)
1111= I2C Slave mode, 10-bit address with Start and Stop bit interrupts enabled
1110= I2C Slave mode, 7-bit address with Start and Stop bit interrupts enabled
1011= I2C Firmware Controlled Master mode (slave Idle)
1000= I2C Master mode, clock = FOSC/(4 * (SSPADD + 1))
0111= I2C Slave mode, 10-bit address
0110= I2C Slave mode, 7-bit address
Note 1: When enabled, the SDA and SCL pins must be properly configured as input or output.
2: Bit combinations not specifically listed here are either reserved or implemented in SPI mode only.
DS39637D-page 202
© 2009 Microchip Technology Inc.
MICROCHIP [ MICROCHIP ]
