PIC16F688
REGISTER 10-2: RCSTA – RECEIVE STATUS AND CONTROL REGISTER (ADDRESS: 17h)
R/W-0
SPEN
R/W-0
RX9
R/W-0
SREN
R/W-0
CREN
R/W-0
R-0
R-0
R-x
ADDEN
FERR
OERR
RX9D
bit 7
bit 0
bit 7
bit 6
bit 5
SPEN: Serial Port Enable bit
1= Serial port enabled (configures RX/DT and TX/CK pins as serial port pins)
0= Serial port disabled (held in Reset)
RX9: 9-bit Receive Enable bit
1= Selects 9-bit reception
0= Selects 8-bit reception
SREN: Single Receive Enable bit
Asynchronous mode:
Don’t care
Synchronous mode - Master:
1= Enables single receive
0= Disables single receive
This bit is cleared after reception is complete.
Synchronous mode - Slave:
Don’t care
bit 4
CREN: Continuous Receive Enable bit
Asynchronous mode:
1= Enables receiver
0= Disables receiver
Synchronous mode:
1= Enables continuous receive until enable bit CREN is cleared (CREN overrides SREN)
0= Disables continuous receive
bit 3
ADDEN: Address Detect Enable bit
Asynchronous mode 9-bit (RX9 = 1):
1= Enables address detection, enable interrupt and load the receive buffer when RSR<8> is
set
0= Disables address detection, all bytes are received and ninth bit can be used as parity bit
Asynchronous mode 8-bit (RX9 = 0):
Don’t care
bit 2
bit 1
bit 0
FERR: Framing Error bit
1= Framing error (can be updated by reading RCREG register and receive next valid byte)
0= No framing error
OERR: Overrun Error bit
1= Overrun error (can be cleared by clearing bit CREN)
0= No overrun error
RX9D: 9th bit of Received Data
This can be address/data bit or a parity bit and must be calculated by user firmware.
Legend:
R = Readable bit
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared x = Bit is unknown
- n = Value at POR
2004 Microchip Technology Inc.
Preliminary
DS41203B-page 79
MICROCHIP [ MICROCHIP ]
