PIC16C63A/65B/73B/74B
4.2.2.5
PIR1 Register
Note: Interrupt flag bits are set when an interrupt
condition occurs, regardless of the state of
its corresponding enable bit, or the global
enable bit, GIE (INTCON<7>). User soft-
ware should ensure the appropriate inter-
rupt flag bits are clear prior to enabling an
interrupt.
This register contains the individual flag bits for the
peripheral interrupts.
REGISTER 4-5:
PIR1 REGISTER (ADDRESS 0Ch)
R/W-0
PSPIF(1)
bit 7
R/W-0
ADIF(2)
R-0
R-0
R/W-0
SSPIF
R/W-0
R/W-0
R/W-0
RCIF
TXIF
CCP1IF TMR2IF
TMR1IF
bit 0
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
PSPIF(1): Parallel Slave Port Read/Write Interrupt Flag bit
1= A read or a write operation has taken place (must be cleared in software)
0= No read or write has occurred
ADIF(2): A/D Converter Interrupt Flag bit
1= An A/D conversion completed (must be cleared in software)
0= The A/D conversion is not complete
RCIF: USART Receive Interrupt Flag bit
1= The USART receive buffer is full (clear by reading RCREG)
0= The USART receive buffer is empty
TXIF: USART Transmit Interrupt Flag bit
1= The USART transmit buffer is empty (clear by writing to TXREG)
0= The USART transmit buffer is full
SSPIF: Synchronous Serial Port Interrupt Flag bit
1= The transmission/reception is complete (must be cleared in software)
0= Waiting to transmit/receive
CCP1IF: CCP1 Interrupt Flag bit
Capture mode:
1= A TMR1 register capture occurred (must be cleared in software)
0= No TMR1 register capture occurred
Compare mode:
1= A TMR1 register compare match occurred (must be cleared in software)
0= No TMR1 register compare match occurred
PWM mode:
Unused in this mode
bit 1
bit 0
TMR2IF: TMR2 to PR2 Match Interrupt Flag bit
1= TMR2 to PR2 match occurred (must be cleared in software)
0= No TMR2 to PR2 match occurred
TMR1IF: TMR1 Overflow Interrupt Flag bit
1= TMR1 register overflowed (must be cleared in software)
0= TMR1 register did not overflow
Note 1: PIC16C63A/73B devices do not have a parallel slave port implemented. This bit loca-
tion is reserved on these devices.
2: PIC16C63A/65B devices do not have an A/D implemented. This bit location is
reserved on these devices.
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
U = Unimplemented bit, read as ‘0’
’0’ = Bit is cleared x = Bit is unknown
’1’ = Bit is set
2000 Microchip Technology Inc.
DS30605C-page 23
MICROCHIP [ MICROCHIP ]
