MX29LV160C T/B
a logical "1" at Q0 for the protected sector.
The system must write the reset command to exit the
"Silicon-ID Read Command" code.
CHIP UNPROTECT
The MX29LV160C T/B also features the chip unprotect
mode, so that all sectors are unprotected after chip
unprotectiscompletedtoincorporateanychangesinthe
code. It is recommended to protect all sectors before
activating chip unprotect mode.
Toactivatethismode,theprogrammingequipmentmust
force VID on control pin OE# and address pin A9. The
CE# pinsmustbesetatVIL. PinsA6mustbesettoVIH.
Refer to chip unprotect algorithm and waveform for the
chip unprotect algorithm. The unprotection mechanism
begins on the falling edge of the WE# pulse and is
terminated on the rising edge.
It is also possible to determine if the chip is unprotected
in the system by writing the Read Silicon ID command.
PerformingareadoperationwithA1=VIH,itwillproduce
00H at data outputs(Q0-Q7) for an unprotected sector.
It is noted that all sectors are unprotected after the chip
unprotect algorithm is completed.
P/N:PM1186
REV. 1.2, JAN. 19, 2006
20
Macronix [ MACRONIX INTERNATIONAL ]
