3. JTAG and In-System Programmability
MII51003-1.6
Introduction
This chapter discusses how to use the IEEE Standard 1149.1 Boundary-Scan Test (BST)
circuitry in MAX II devices and includes the following sections:
■
“IEEE Std. 1149.1 (JTAG) Boundary-Scan Support” on page 3–1
“In System Programmability” on page 3–4
■
IEEE Std. 1149.1 (JTAG) Boundary-Scan Support
®
All MAX II devices provide Joint Test Action Group (JTAG) boundary-scan test (BST)
circuitry that complies with the IEEE Std. 1149.1-2001 specification. JTAG boundary-
scan testing can only be performed at any time after VCCINT and all VCCIO banks have
been fully powered and a tCONFIG amount of time has passed. MAX II devices can also
®
use the JTAG port for in-system programming together with either the Quartus II
software or hardware using Programming Object Files (.pof), JamTM Standard Test
and Programming Language (STAPL) Files (.jam), or Jam Byte-Code Files (.jbc).
The JTAG pins support 1.5-V, 1.8-V, 2.5-V, or 3.3-V I/O standards. The supported
voltage level and standard are determined by the VCCIO of the bank where it resides.
The dedicated JTAG pins reside in Bank 1 of all MAX II devices.
MAX II devices support the JTAG instructions shown in Table 3–1.
Table 3–1. MAX II JTAG Instructions (Part 1 of 2)
JTAG Instruction
Instruction Code
Description
SAMPLE/PRELOAD
00 0000 0101
Allows a snapshot of signals at the device pins to be captured and
examined during normal device operation, and permits an initial data
pattern to be output at the device pins.
EXTEST(1)
BYPASS
00 0000 1111
11 1111 1111
00 0000 0111
Allows the external circuitry and board-level interconnects to be
tested by forcing a test pattern at the output pins and capturing test
results at the input pins.
Places the 1-bit bypass register between the TDIand TDOpins,
which allows the BST data to pass synchronously through selected
devices to adjacent devices during normal device operation.
USERCODE
Selects the 32-bit USERCODEregister and places it between the
TDIand TDOpins, allowing the USERCODEto be serially shifted
out of TDO. This register defaults to all 1’s if not specified in the
Quartus II software.
IDCODE
00 0000 0110
00 0000 1011
Selects the IDCODEregister and places it between TDIand TDO,
allowing the IDCODEto be serially shifted out of TDO.
HIGHZ(1)
Places the 1-bit bypass register between the TDIand TDOpins,
which allows the boundary scan test data to pass synchronously
through selected devices to adjacent devices during normal device
operation, while tri-stating all of the I/O pins.
© October 2008 Altera Corporation
MAX II Device Handbook
INTEL [ INTEL ]
