MAX II Architecture
Figure 2–23. MAX II I/O Banks for EPM1270 & EPM2210
Notes (1), (2)
I/O Bank 2
Also Supports
the 3.3-V PCI
I/O Standard
All I/O Banks Support
■ 3.3-V LVTTL/LVCMOS
■ 2.5-V LVTTL/LVCMOS
■ 1.8-V LVTTL/LVCMOS
■ 1.5-V LVCMOS
I/O Bank 1
I/O Bank 3
I/O Bank 4
Notes to Figure 2–23:
(1) Figure 2–23 is a top view of the silicon die.
(2) Figure 2–23 is a graphic representation only. Refer to the pin list and the Quartus II software for exact pin locations.
Each I/O bank has dedicated VCCIOpins which determine the voltage
standard support in that bank. A single device can support 1.5-V, 1.8-V,
2.5-V, and 3.3-V interfaces; each individual bank can support a different
standard. Each I/O bank can support multiple standards with the same
VCCIO for input and output pins. For example, when VCCIO is 3.3 V, Bank 3
can support LVTTL, LVCMOS, and 3.3-V PCI. VCCIO powers both the
input and output buffers in MAX II devices.
The JTAG pins for MAX II devices are dedicated pins that cannot be used
as regular I/O pins. The pins TMS, TDI, TDO, and TCKsupport all the I/O
standards shown in Table 2–4 on page 2–33 except for PCI. These pins
reside in Bank 1 for all MAX II devices and their I/O standard support is
controlled by the VCCIO setting for Bank 1.
Altera Corporation
August 2006
Core Version a.b.c variable
2–35
MAX II Device Handbook, Volume 1