A10-DATASHEET
2015.12.31
106
Document Revision History
Date
Version
Changes
•
•
Made the following changes to the "Transceiver Performance for Arria 10 GT Devices" section.
•
•
Added TX minimum data rate to the "Transmitter and Receiver Data Rate Performance" table.
Changed the maximum data rate condition for chip-to-chip and backplane in the "Transmitter and
Receiver Data Rate Performance" table.
•
•
•
Changed the minimum frequency in the "ATX PLL Performance" table.
Changed the minimum frequency in the "Fractional PLL Performance" table.
Changed the minimum frequency in the "CMU PLL Performance" table.
Added voltage condition to the maximum peak-to-peak diff p-p after configuration and to the VICM specifi‐
cations in the "Receiver Specifications" table.
•
•
•
Changed the voltage conditions for VOCM in the "Transmitter Specifications" table.
Changed the VOD/VCCT Ratios in the "Typical Transmitter VOD Settings" table.
Added the "Transceiver Clock Network Maximum Data Rate Specifications" table.
January 2015
2015.01.23
•
•
Added a note in the "Transceiver Power Supply Operating Conditions" section.
Made the following changes to the "Reference Clock Specifications" table:
•
•
•
•
Added the input reference clock frequency parameters for the CMU PLL, ATX PLL, and fPLL PLL.
Changed the maximum specification for rise time and fall time.
Added the VICM (AC and DC coupled) parameters.
Changed the maximum value for Transmitter REFCLK Phase Noise (622 MHz) when ≥ 1 MHz.
•
•
Changed the Min, Typ, and Max values for the reconfig_clksignal in the "Transceiver Clocks Specifica‐
tions" table.
Made the following changes to the "Receiver Specifications" table:
•
•
Added the maximum peak-to-peak differential input voltage after device configuration specifications.
Changed the minimum specification for the minimum differential eye opening at receiver serial input
pins parameter.
•
Removed the 120-ohm and 150-ohm conditions for the differential on-chip termination resistors
parameter.
•
•
Added the VICM (AC and DC coupled) parameter.
Added the Programmable DC Gain parameter.
Arria 10 Device Datasheet
Send Feedback
Altera Corporation