PEB 2091
PEF 2091
Programming
6
Programming
This chapter contains a summery of commands and indications used to program the
IEC-Q. An overview of the following codes is given
• C/I channel commands and indications
• Predefined Monitor channel messages
• Predefined EOC messages
Furthermore, several examples for programming codes are given. This includes
• programming code for the C/I and the Monitor channel in the microprocessor mode
(sections 6.4 and 6.5)
• Programming code for the power controller interface, which applies only in
stand-alone mode (section 6.6)
• Programming code for test loop-backs (section 6.7)
• Programming code for activation and deactivation control for all important
configurations (section 6.8)
Note 65: Programming the C/I channel and the Monitor channel can be performed
using either the IOM®-2 interface, which is available in every mode, or the µP
interface if the µP mode is used. A combination of both is also possible in the
µP mode.
For information about the IOM®-2 interface characteristics, see "IOM®-2
Interface", page 70. See also "Microprocessor Access to IOM®-2 Channels",
page 97, for the µP mode.
Semiconductor Group
223
Data Sheet 01.99