PEB 2091
PEF 2091
Register Description
MDR
B1
Monitor data receive mask
1=
0=
Prevents an interrupt ISTA:MDR to influence the INT pin
Disables the function described above
B1-channel mask
1=
0=
Prevents an interrupt ISTA:B1 to influence the INT pin
Disables the function described above
B2
B2-channel mask
1=
0=
Prevents an interrupt ISTA:B2 to influence the INT pin
Disables the function described above
MDA
Monitor data transmit mask
1=
0=
Prevents an interrupt ISTA:MDA to influence the INT pin
Disables the function described above
5.2.3
STCR-Register
Write
Address 1
H
The Status Control Register (STCR) selects the operating modes of the IEC-Q as given
in Table 2, "Setting Modes of Operation (Stand-Alone and µP Mode)", on page 51.
Note 64: The STCR-register is only reset after a power-on. Please refer also to
"Reset Behavior", page 94.
Reset value: 04H
7
6
5
4
3
2
1
0
BURST
LT
TS2
TS1
TS0
TM1
TM2 AUTO
BURST
LT
Selection of burst modes
1=
0=
Selects the burst modes (LT, NT-PBX)
Selects the non-burst modes (NT, TE, COT-512/1536, LT/NT-RP)
Selection of LT modes
1=
0=
Selects the LT modes (LT,COT-512/1536, LT-RP)
Selects the non LT modes (NT, TE, NT-PBX, NT-RP)
Semiconductor Group
212
Data Sheet 01.99