.
Preliminary
Features
IBMB3N16644JCB
IBMB3N16734JCB
16M x 64/72 One-Bank Unbuffered SDRAM Module
• 168-Pin Unbuffered 8-Byte Dual In-Line Memory
Module
• Intended for PC133 applications
- Clock Frequency: 133MHz
- Clock Cycle: 7.5ns
- Clock Assess Time: 5.4ns
• Inputs and outputs are LVTTL (3.3V) compatible
• Single 3.3V
±
0.3V Power Supply
• Single Pulsed RAS interface
• SDRAMs have 4 internal banks
• Module has 1 physical bank
• Fully Synchronous to positive Clock Edge
• Data Mask for Byte Read/Write control
• Auto Refresh (CBR) and Self Refresh
• Automatic and controlled Precharge commands
• Programmable Operation:
- CAS Latency: 3
- Burst Type: Sequential or Interleave
- Burst Length: 1, 2, 4, 8
- Operation: Burst Read and Write or Multiple
Burst Read with Single Write
• Suspend Mode and Power Down Mode
• 12/10/2 Addressing (Row/Column/Bank)
• 4096 Refresh cycles distributed across 64ms
• Card size: 5.25" x 1.375" x 0.106"
• Gold contacts
• SDRAMs in TSOP Type II Package
• Serial Presence Detect with Write Protect
Description
IBMB3N16644JCB / IBMB3N16734JCB are unbuf-
fered 168-pin Synchronous DRAM Dual In-Line
Memory Modules (DIMMs) which are organized as
16Mx64 and 16Mx72 high-speed memory arrays
and are configured as one 16M x 64/72 physical
bank. The DIMMs use eight (16Mx64) or nine
(16Mx72) 16Mx8 SDRAMs in 400mil TSOP II pack-
ages. The DIMMs achieve high-speed data transfer
rates of up to 133MHz by employing a prefetch/pipe-
line hybrid architecture that supports the JEDEC 1N
rule while allowing very low burst power.
All control, address, and data input/output circuits
are synchronized with the positive edge of the exter-
nally supplied clock inputs.
All inputs are sampled at the positive edge of each
externally supplied clock (CK0, CK2). Internal oper-
ating modes are defined by combinations of RAS,
CAS, WE, S0/S2, DQMB, and CKE0 signals. A
command decoder initiates the necessary timings
for each operation. A 14-bit address bus accepts
address information in a row/column multiplexing
arrangement.
Prior to any Access operation, the CAS latency,
burst type, burst length, and Burst operation type
must be programmed into the DIMM by address
inputs A0-A9 during the Mode Register Set cycle.
The DIMM uses serial presence detects imple-
mented via a serial EEPROM using the two-pin IIC
protocol. The first 128 bytes of serial PD data are
used by the DIMM manufacturer. The last 128 bytes
are available to the customer.
All IBM 168-pin DIMMs provide a high-performance,
flexible 8-byte interface in a 5.25" long space-saving
footprint.
Card Outline
(Front) 1
(Back) 85
10 11
94 95
40 41
124 125
84
168
75H2785.H42054
11/00
©IBM Corporation. All rights reserved.
Use is further subject to the provisions at the end of this document.
Page 1 of 18
IBM [ IBM ]
