IBM0316809C IBM0316409C
IBM0316169C
16Mbit Synchronous DRAM
=
Burst Mode Operation
Burst mode operation is used to provide a constant flow of data to memory locations (write cycle), or from
memory locations (read cycle). There are three parameters that define how the burst mode will operate.
These parameters include burst sequence, burst length, and operation mode. The burst sequence and burst
length are programmable, and are determined by address bits A0 - A3 during the Mode Register Set com-
mand. Operation mode is also programmable and is set by address bits A7 - A10 and BS.
The burst type is used to define the order in which the burst data will be delivered or stored to the SDRAM.
Two types of burst sequences are supported, sequential and interleaved. See Table.
The burst length controls the number of bits that will be output after a Read Command, or the number of bits
to be input after a Write Command. The burst length can be programmed to have values of 1, 2, 4, 8 or full
page (actual page length is dependent on organization: x4, x8, or x16 ). Full page burst operation is only pos-
sible using the sequential burst type.
Burst operation mode can be normal operation or multiple burst with single write operation. Normal operation
implies that the device will perform burst operations on both read and write cycles until the desired burst
length is satisfied. Multiple burst with single write operation was added to support Write Through Cache oper-
ation. Here, the programmed burst length only applies to read cycles. All write cycles are single write opera-
tions when this mode is selected.
Burst Length and Sequence
Burst Length
Starting Address (A2 A1 A0)
Sequential Addressing (decimal)
0, 1
Interleave Addressing (decimal)
0, 1
x x 0
x x 1
x 0 0
x 0 1
x 1 0
x 1 1
0 0 0
0 0 1
0 1 0
0 1 1
1 0 0
1 0 1
1 1 0
1 1 1
n n n
2
1, 0
1, 0
0, 1, 2, 3
0, 1, 2, 3
1, 2, 3, 0
1, 0, 3, 2
4
2, 3, 0, 1
2, 3, 0, 1
3, 0, 1, 2
3, 2, 1, 0
0, 1, 2, 3, 4, 5, 6, 7
1, 2, 3, 4, 5, 6, 7, 0
2, 3, 4, 5, 6, 7, 0, 1
3, 4, 5, 6, 7, 0, 1, 2
4, 5, 6, 7, 0, 1, 2, 3
5, 6, 7, 0, 1, 2, 3, 4
6, 7, 0, 1, 2, 3, 4, 5
7, 0, 1, 2, 3, 4, 5, 6
Cn, Cn+1, Cn+2, ......
0, 1, 2, 3, 4, 5, 6, 7
1, 0, 3, 2, 5, 4, 7, 6
2, 3, 0, 1, 6, 7, 4, 5
3, 2, 1, 0, 7, 6, 5, 4
4, 5, 6, 7, 0, 1, 2, 3
5, 4, 7, 6, 1, 0, 3, 2
6, 7, 4, 5, 2, 3, 0, 1
7, 6, 5, 4, 3, 2, 1, 0
Not Supported
8
Full Page (Note)
Note: Page length is a function of I/O organization and column addressing.
X4 organization (CA0-CA9); Page Length = 1024 bits
X8 organization (CA0-CA8); Page Length = 512 bits
X16 organization (CA0-CA7); Page Length = 256 bits
©IBM Corporation, 1996. All rights reserved.
Use is further subject to the provisions at the end of this document.
07H3997
SA14-4711-02
Revised 05/96
Page 10 of 100
IBM [ IBM ]
