FH33 Seriesꢀ0.4mm,0.5 mm,1mm Pitch, 1.2 mm above the board, Flexible Printed Circuit & Flexible Flat Cable ZIF Connectors
Precautions
SVerification of the fully closed actuator.
The actuator should be fully closed (as illustrated) and the FPC held firmly in the connector.
Do not press against the actuator when is fully closed. Max force applied to the fully closed actuator should
not exceed 1 N.
Routing the FPC (FPC fully inserted/ actuator closed)
SFPC Load
Do not apply force in excess of 0.15N max. in the upward direction (as illustrated). Do not bend the FPC
too close to the actuator.
Load: 0.15N max.
Removing the FPC
Rotate the actuator to the open position (maximum open angle of 120°). Carefully withdraw the FPC.
Other Precautions
SHand Soldering Precautions
When hand soldering:
1
2
3
Do not perform reflow or hand soldering with the FPC inserted in the connector.
Do not apply excessive heat or touch the soldering iron anywhere other than the connector leads.
Do not use excessive amount of solder or flux compounds.
Operation of the actuator and contacts may be affected by excessive amounts of solder or flux
compounds.
14
HRS [ HRS ]
