HMC382LP3
/
382LP3E
v01.0610
GaAs PHEMT MMIC
LOW NOISE AMPLIFIER, 1.7 - 2.2 GHz
7
AMPLIFIERS - LOW NOISE - SMT
Pin Descriptions
Pin Number
1, 4, 5, 7, 9,
12, 14, 16
Function
N/C
Description
No connection necessary. These pins may be connected to
RF/DC ground. Performance will not be affected.
Interface Schematic
2
RFIN
This pin is AC coupled and matched to 50 Ohms.
3, 6, 10
GND
These pins and package bottom must
be connected to RF/DC ground.
8
Res
This pin is used to set the DC current of the amplifier
by selection of external bias resistor.
See application circuit.
11
RFOUT
This pin is AC coupled and matched to 50 Ohms.
13,15
Vdd2, Vdd1
Power supply voltage. Choke inductor and bypass
capacitors are required. See application circuit.
Application Circuit
Note: L1, L2 and C1 should be located as close to pins as possible.
7-5
For price, delivery, and to place orders, please contact Hittite Microwave Corporation:
20 Alpha Road, Chelmsford, MA 01824 Phone: 978-250-3343 Fax: 978-250-3373
Order On-line at www.hittite.com