Document Reference No.: FT_000016
VDIP1 Vinculum VNC1L Module Datasheet Version 1.01
Clearance No.: FTDI# 131
`
3.3 I/O Configuration Using The Jumper Pin Header
Two three way jumper pin headers are provided to allow for simple configuration of the I/O on data and
control bus pins of the VDIP1. This is done by a combination of pulling up or pulling down the VNC1L
ACBUS5 (pin 46) and ACBUS6 (pin 47). The relevant portion of the VDIP1 module schematic is shown in
Figure 3.2 – VDIP1 On-Board Jumper Pin Configuration.
ACBUS6
(VNC1L pin 47)
Pull-Up
Pull-Up
Pull-Down
Pull-Down
Pull-Up
ACBUS5
(VNC1L pin 46)
I/O Mode
Serial UART
SPI
Parallel FIFO
Serial UART
Pull-Down
Pull-Up
Pull-Down
Table 3.2 - VDIP1 Port Selection Jumper Pins
Copyright © 2010 Future Technology Devices International Limited
6