Document No.: FT_000288
FT232H SINGLE CHANNEL HI-SPEED USB TO MULTIPURPOSE UART/FIFO IC
Datasheet Version 1.3
Clearance No.: FTDI #199
4.9 Fast Serial Interface Mode Description
Fast Serial Interface Mode provides a method of communicating with an external device over USB using 4
wires that can have opto-isolators in their path, thus providing galvanic isolation between systems. Fast
serial mode is enabled by setting the appropriate bits in the external EEPROM. The fast serial mode can
be held in reset by setting a bit value of 0x10 using the FT_SetBitMode D2xx driver command. While this
bit is set the device is held reset – data can be sent to the device, but it will not be sent out by the device
until the device is enabled again. This is done by sending a bit value of 0x00 using the Set Bit Mode
command.
When the FT232H is configured in Fast Serial Interface mode the IO timing of the signals used are shown
in Figure 4.17 and the timings are shown in Table 4.5 Fast Serial Interface Signal Timings.
Figure 4.17 Fast Serial Interface Signal Waveforms
Name
t1
t2
t3
t4
t5
t6
t7
Minimum Typical
5
5
5
10
10
10
20
Maximu
Units
ns
ns
ns
ns
ns
ns
ns
Description
FSDO/FSC TS hold time
FSDO/FSC TS setup time
FSDI hold time
FSDI Setup Time
FSC LK low
FSC LK high
FSC LK Period
Table 4.5 Fast Serial Interface Signal Timings
Copyright © 2011 Future Technology Devices International Limited
37
FTDI [ FUTURE TECHNOLOGY DEVICES INTERNATIONAL LTD. ]
