Table 3-2 Recommended Operating Conditions
Characteristic
Symbol
ΔVSS
VREF
TA
Min
-0.1
2.7
Typ
Max
0.1
Unit
V
Voltage difference VSS to VSSA
-
ADC reference voltage
–
–
VDDA
85
V
Ambient operating temperature
–40
°C
6
Table 3-3 Thermal Characteristics
Value
Characteristic
Symbol
Unit
Notes
Comments
160-pin
LQFP
160
MBGA
Junction to ambient
Natural convection
RθJA
38.5
63.4
°C/W
2
Junction to ambient (@1m/sec)
RθJMA
35.4
33
60.3
49.9
°C/W
°C/W
2
Junction to ambient
Natural convection
Four layer
board (2s2p)
RθJMA
(2s2p)
1,2
Junction to ambient (@1m/sec)
Four layer
RθJMA
31.5
46.8
°C/W
1,2
board (2s2p)
Junction to case
RθJC
ΨJT
8.6
0.8
8.1
0.6
°C/W
°C/W
W
3
Junction to center of case
I/O pin power dissipation
Power dissipation
4, 5
P I/O
P D
User Determined
P D = (IDD x VDD + P I/O
(TJ - TA) /RθJA
)
W
Junction to center of case
PDMAX
W
7
Notes:
1. Theta-JA determined on 2s2p test boards is frequently lower than would be observed in an application.
Determined on 2s2p thermal test board.
2. Junction to ambient thermal resistance, Theta-JA (RθJA) was simulated to be equivalent to the JEDEC
specification JESD51-2 in a horizontal configuration in natural convection. Theta-JA was also simulated on
a thermal test board with two internal planes (2s2p where “s” is the number of signal layers and “p” is the
number of planes) per JESD51-6 and JESD51-7. The correct name for Theta-JA for forced convection or with
the non-single layer boards is Theta-JMA.
3. Junction to case thermal resistance, Theta-JC (RθJC ), was simulated to be equivalent to the measured values
using the cold plate technique with the cold plate temperature used as the “case” temperature. The basic cold
plate measurement technique is described by MIL-STD 883D, Method 1012.1. This is the correct thermal
metric to use to calculate thermal performance when the package is being used with a heat sink.
56F807 Technical Data Technical Data, Rev. 16
22
Freescale Semiconductor
FREESCALE [ Freescale ]
