AT commands
Networking and security commands
on the destination device's MY command configuration.
2. The receiving device returns OK (or ERROR).
3. The device exits Command mode to allow for immediate communication. If an ERROR is
received, then Command mode does not exit.
When DN is sent as a local AT Command API frame:
1. The receiving device returns the 16-bit network and 64-bit extended addresses in an API
Command Response frame.
2. If there is no response from a module within (NT* 100) milliseconds or you do not specify a
parameter (by leaving it blank), the receiving device returns an ERROR message. In the case of
an ERROR, the device does not exit command mode. Set the radius of the DN command using
the BH command.
When DN is sent as a local Local AT Command Request - 0x08:
1. The receiving device returns a success response in a Local AT Command Response - 0x88.
2. If there is no response from a module within (NT * 100) milliseconds or you do not specify a
parameter (by leaving it blank), the receiving device returns an ERROR message.
Parameter range
20-byte ASCII string
Default
N/A
CE (Coordinator Enable)
This command applies to the XBee/XBee-PRO S2C 802.15.4 RF Module.
The routing and messaging mode of the device.
Parameter range
0 - 1
Parameter
Description
End Device
Coordinator
0
1
Default
0
SC (Scan Channels)
This command applies to the XBee/XBee-PRO S2C 802.15.4 RF Module.
Sets or displays the list of channels to scan for all Active and Energy Scans as a bit field. This affects
scans initiated in the AS (Active Scan) and ED (Energy Scan) commands in Command mode and
during End Device Association and Coordinator startup.
XBee/XBee-PRO S2C 802.15.4 RF Module User Guide
75
ETC [ ETC ]
