AT commands
Networking and security commands
AI (Association Indication)
This command applies to the XBee/XBee-PRO S2C 802.15.4 RF Module.
Reads the Association status code to monitor association progress. The following table provides the
status codes and their meanings.
Status
code
Meaning
0x00
Coordinator successfully started, End device successfully associated, or operating in peer
to peer mode where no association is needed.
0x03
0x04
Active Scan found a PAN coordinator, but it isn't currently accepting associations.
Active Scan found a PAN coordinator in a beacon-enabled network, which is not a
supported feature.
Active Scan found a PAN, but the PAN ID doesn't match the configured PAN ID on the
requesting end device and bit 0 of A1 is not set to allow reassignment of PAN ID.
0x05
0x06
Active Scan found a PAN on a channel that does not match the configured channel on the
requesting end device and bit 1 of A1 is not set to allow reassignment of the channel.
0x0C
0x13
0xFF
Association request failed to get a response.
End device is disassociated or is in the process of disassociating.
Initialization time; no association status has been determined yet.
Parameter range
0 - 0x13 [read-only]
Default
N/A
DA (Force Disassociation)
This command applies to the XBee/XBee-PRO S2C 802.15.4 RF Module.
Causes the End Device to immediately disassociate from a Coordinator (if associated) and re-attempt
to associate.
Parameter range
-
Default
-
FP (Force Poll)
This command applies to the XBee/XBee-PRO S2C 802.15.4 RF Module.
The FP command is deferred until changes are applied. This prevents indirect messages from arriving
at the end device while it is operating in Command mode.
XBee/XBee-PRO S2C 802.15.4 RF Module User Guide
79
ETC [ ETC ]
