Epson Research and Development
Page 23
Vancouver Design Center
4.5 MediaPlug Interface
®
The S5U13506B00C supports the Winnov Videum Cam digital camera through the
®
S1D13506 built-in MediaPlug interface. The Winnov Videum Cam digital camera inputs
are TTL compatible and can be driven by the S1D13506 powered at 3.3V or 5V. Therefore,
the power supply to the camera is 5V while the S1D13506 can powered at 3.3V or 5V.
However, if the S1D13506 is powered at 5V, then 150nH inductors must be added at
locations L8, L10, L11, L12 and L13.
Jumper JP5 selects whether MA11/GPIO2 is used to enable the video camera power. For
more information, see the note from Section 3.2, “Configuration Jumpers” on page 10.
Eight jumpers identified globally as JP3 must be set for MediaPlug operation.
The table below describes the S1D13506 pin mapping for the MediaPlug interface.
Table 4-9: MediaPlug Connector (J5) Pin Mapping
S1D13506
Pin Names
Connector Pin
No.
IO Type
MediaPlug I/F
FPDAT8
1
O
I
VMPLCTL
VMPRCTL
VMPD0
FPDAT9
2
FPDAT10
FPDAT11
FPDAT12
FPDAT13
FPDAT14
FPDAT15
MA11/GPIO2
GND
3
IO
IO
IO
IO
O
O
O
-
4
VMPD1
6
VMPD2
5
VMPD3
8
VMPCLK
VMPCLKN
VMPEPWR
Ground
7
9
Shield
Note
When MediaPlug is enabled, 16-bit passive panels support requires an external circuit.
See Section 4.3.3, “16-bit Passive Color Panel Support with MediaPlug Enabled” on
page 20.
S5U13506B00C Evaluation Board User Manual
Issue Date: 01/02/06
S1D13506
X25B-G-004-06
EPSON [ EPSON COMPANY ]
