SL811HS
Interrupt Status Register, Address [Address = 0Dh]. The Interrupt Status register is a READ/WRITE register providing interrupt
status. Interrupts are cleared by writing to this register. To clear a specific interrupt, the register is written with corresponding bit set
to ’1’.
Table 14. Interrupt Status Register [Address 0Dh]
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
D+
Device
Detect/Resume
Insert/Remove SOF timer
Reserved
Reserved
USB-B
USB-A
Bit Position
Bit Name
Function
7
D+
Value of the Data+ pin.
Bit 7 provides continuous USB Data+ line status. Once it is determined that a device
is inserted (as described below) with bits 5 and 6, bit 7 is used to detect if the inserted
device is low speed (0) or full speed (1).
6
5
Device Detect/Resume Device Detect/Resume Interrupt.
Bit 6 is shared between Device Detection status and Resume Detection interrupt.
When bit-6 of register 05h is set to one, this bit is the Resume detection Interrupt bit.
Otherwise, this bit is used to indicate the presence of a device, ’1’ = device ‘Not present’
and ’0’ = device ‘Present.’ In this mode, check this bit along with bit 5 to determine
whether a device has been inserted or removed.
Insert/Remove
Device Insert/Remove Detection.
Bit 5 is provided to support USB cable insertion/removal for the SL811HS in host mode.
This bit is set when a transition from SE0 to IDLE (device inserted) or from IDLE to
SE0 (device removed) occurs on the bus.
4
3
2
1
0
SOF timer
Reserved
Reserved
USB-B
‘1’ = Interrupt on SOF Timer.
‘0’
‘0’
USB-B Done Interrupt. (See description in Interrupt Enable Register [address 06h].)
USB-A Done Interrupt. (See description in Interrupt Enable Register [address 06h].)
USB-A
Current Data Set Register/Hardware Revision/SOF Counter LOW [Address = 0Eh]. This register has two modes. Read from this
register indicates the current SL811HS silicon revision.
Table 15. Hardware Revision when Read [Address 0Eh]
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Hardware Revision
Reserved
Bit Position
Bit Name
Function
7-4
3-2
1-0
Hardware Revision
Reserved
SL811HS rev1.2 Read = 1H; SL811HS rev1.5 Read = 2.
Read is zero.
Reserved
Reserved for slave.
Writing to this register sets up auto generation of SOF to all connected peripherals. This counter is based on the 12 MHz clock and
is not dependent on the crystal frequency. To set up a 1 ms timer interval, the software must set up both SOF counter registers to the
proper values.
Document 38-08008 Rev. *F
Page 12 of 32
[+] Feedback
CYPRESS [ CYPRESS ]
