ACM100
Environmental Specifications
Specification
Value
Comment
See General Specifications for sensitivity de-rating
over temperature. Video performance guaranteed
from –40°C to +85 °C
Normal Operating Temperature
– 40°C to +85°C
Degraded Operating
Temperature
– 40°C to +115 °C
– 40°C to +130 °C
Storage Temperature
Humidity
100% relative humidity
Salt Mist Atmosphere
Dust
Passenger compartment compliant
3
100 mg/m
Passenger compartment compliant
Leather wax, anti-mist spray, cleaning soap, deodoriz-
Chemical Resistance
Passenger compartment compliant er spray, coffee, tea, soft drinks
Performance Specifications
The ACM100 module is intended to support a variety of applications, many with differing optical field of view requirements. To
facilitate the differences, the ACM100 module is available with a selection of lenses. The following table summarizes the general
o
performance of the camera and at 25 C. Data are for imager (IM103) performance. Performance specifications will vary based
on lens selection. Specifications of available lenses are described in later sections.
Parameter
Resolution
FPN
Value
Notes
640H X 480V
Additional columns/rows for image processing
Excluding temporal noise sources
<0.1% of full signal rms
Standarddeviationfromthemeanphotoresponse
from 10 to 90% of full signal
Response nonuniformity
<1.0% rms
850nm faceplate power SNR>10 required @
30fps and 85 C (Signal over temporal noise)
Minimum illumination
Responsivity
1 mW/m2
>10 V/lux-sec
1.5 nW/cm2 @ 525 nm
3 nW/cm2 @ 850 nm
6 nW/cm2 @ 940 nm
irradiance required to achieve an SNR of 1
Configurable defect correction available
Noise Equivalent Irradiation
Pixel pitch
8 microns square
<80
0 clusters
Defective Pixels
Online temperature estimate
Dynamic Range
Mean dark signal register
120 dB captured
Document Number: 001-05325 Rev. **
Page 18 of 20