CS4365
5. REGISTER DESCRIPTION
2
Note: All registers are read/write in I C mode and write only in SPI, unless otherwise noted.
5.1
Chip Revision (address 01h)
7
PART4
0
6
PART3
1
5
PART2
1
4
PART1
0
3
PART0
1
2
REV2
-
1
REV1
-
0
REV0
-
5.1.1 Part Number ID (part) [Read Only]
01101 - CS4365
Revision ID (REV) [Read Only]
000 - Revision A
Function:
This read-only register can be used to identify the model and revision number of the device.
5.2
Mode Control 1 (address 02h)
7
CPEN
0
6
FREEZE
0
5
DSD/PCM
0
4
Reserved
0
3
2
1
0
PDN
1
DAC3_DIS DAC2_DIS DAC1_DIS
0
0
0
5.2.1 Control Port Enable (CPEN)
Default = 0
0 - Disabled
1 - Enabled
Function:
This bit defaults to 0, allowing the device to power-up in Stand-Alone mode. The Control port mode can be
accessed by setting this bit to 1. This will allow the operation of the device to be controlled by the registers
and the pin definitions will conform to Control Port Mode. To accomplish a clean power-up, the user should
write this bit within 10 ms following the release of Reset.
5.2.2 Freeze Controls (Freeze)
Default = 0
0 - Disabled
1 - Enabled
Function:
This function allows modifications to be made to the registers without the changes taking effect until the
FREEZE is disabled. To make multiple changes in the Control port registers take effect simultaneously, en-
able the FREEZE Bit, make all register changes, then Disable the FREEZE bit.
34
DS670PP1
CIRRUS [ CIRRUS LOGIC ]
