欢迎访问ic37.com |
会员登录 免费注册
发布采购

ATMEGA2560-16AU-SL383 参数 Datasheet PDF下载

ATMEGA2560-16AU-SL383图片预览
型号: ATMEGA2560-16AU-SL383
PDF下载: 下载PDF文件 查看货源
内容描述: [Microcontroller, 8-Bit, FLASH, AVR RISC CPU, 16MHz, CMOS, PQFP100, 14 X 14 MM, 1 MM HEIGHT, 0.50 MM PITCH, GREEN, PLASTIC, MS-026AED, TQFP-100]
分类和应用: 时钟微控制器
文件页数/大小: 448 页 / 7518 K
品牌: ATMEL [ ATMEL ]
 浏览型号ATMEGA2560-16AU-SL383的Datasheet PDF文件第203页浏览型号ATMEGA2560-16AU-SL383的Datasheet PDF文件第204页浏览型号ATMEGA2560-16AU-SL383的Datasheet PDF文件第205页浏览型号ATMEGA2560-16AU-SL383的Datasheet PDF文件第206页浏览型号ATMEGA2560-16AU-SL383的Datasheet PDF文件第208页浏览型号ATMEGA2560-16AU-SL383的Datasheet PDF文件第209页浏览型号ATMEGA2560-16AU-SL383的Datasheet PDF文件第210页浏览型号ATMEGA2560-16AU-SL383的Datasheet PDF文件第211页  
ATmega640/1280/1281/2560/2561  
Figure 22-1. USART Block Diagram(1)  
Clock Generator  
UBRR[H:L]  
OSC  
BAUD RATE GENERATOR  
SYNC LOGIC  
PIN  
CONTROL  
XCK  
TxD  
RxD  
Transmitter  
TX  
CONTROL  
UDR (Transmit)  
PARITY  
GENERATOR  
PIN  
CONTROL  
TRANSMIT SHIFT REGISTER  
Receiver  
CLOCK  
RECOVERY  
RX  
CONTROL  
DATA  
RECOVERY  
PIN  
CONTROL  
RECEIVE SHIFT REGISTER  
PARITY  
CHECKER  
UDR (Receive)  
UCSRA  
UCSRB  
UCSRC  
Note:  
1. See Figure 1-1 on page 2, Figure 1-3 on page 4, Table 1 on page 83, Table 13-14 on page 86,  
Table 13-23 on page 92 and Table 13-26 on page 95 for USART pin placement.  
The dashed boxes in the block diagram separate the three main parts of the USART (listed from  
the top): Clock Generator, Transmitter and Receiver. Control Registers are shared by all units.  
The Clock Generation logic consists of synchronization logic for external clock input used by  
synchronous slave operation, and the baud rate generator. The XCKn (Transfer Clock) pin is  
only used by synchronous transfer mode. The Transmitter consists of a single write buffer, a  
serial Shift Register, Parity Generator and Control logic for handling different serial frame for-  
mats. The write buffer allows a continuous transfer of data without any delay between frames.  
The Receiver is the most complex part of the USART module due to its clock and data recovery  
units. The recovery units are used for asynchronous data reception. In addition to the recovery  
units, the Receiver includes a Parity Checker, Control logic, a Shift Register and a two level  
receive buffer (UDRn). The Receiver supports the same frame formats as the Transmitter, and  
can detect Frame Error, Data OverRun and Parity Errors.  
22.2 Clock Generation  
The Clock Generation logic generates the base clock for the Transmitter and Receiver. The  
USARTn supports four modes of clock operation: Normal asynchronous, Double Speed asyn-  
chronous, Master synchronous and Slave synchronous mode. The UMSELn bit in USART  
Control and Status Register C (UCSRnC) selects between asynchronous and synchronous  
operation. Double Speed (asynchronous mode only) is controlled by the U2Xn found in the  
207  
2549L–AVR–08/07  
 复制成功!