TS68882
Mechanical and
Environmental
The microcircuits shall meet all mechanical environmental requirements of either MIL-
STD-883 for class B devices.
Marking
The document defines the markings that are identified in the related reference docu-
ments. Each microcircuit is legible and permanently marked with the following
information as minimum:
•
•
•
•
•
•
Atmel-Grenoble Logo
Manufacturer’s Part Number
Class B Identification
Date-code of inspection lot
ESD Identifier if Available
Country of Manufacturing
Quality Conformance
Inspection
DESC/MIL-STD-883
Is in accordance with MIL-M-38510 and method 5005 of MIL-STD-883. Group A and B
inspections are performed on each production lot. Group C and D inspection are per-
formed on a periodical basis.
Electrical
Characteristics
General Requirements
All static and dynamic electrical characteristics specified and the relevant measurement
conditions are given below. For inspection purpose, refer to relevant specification:
Static electrical characteristics for all electrical variants.
Dynamic electrical characteristics for 68882-16 (16.67 MHz), 68882-20 (20 MHz),
68882-25 (25 MHz) and 68882-33 (33 MHz).
For static characteristics, test methods refer to clause “Test Load” on page 13 hereafter
of this specification (Table 5).
For dynamic characteristics (Tables 6 and 7), test methods refer to IEC 748-2 method
number, where existing.
Table 5. Static Characteristics
VCC = 5.0 VDC 10%; GND = 0 VDC; Tc = -55/+125°C or -40/+85°C
Symbol
VIH
Parameter
Min
2.0
Max
VCC
0.8
10
Unit
V
Input High Voltage
VIL
Input Low Voltage
GND - 0.3
V
IIN
Input Leakage Current at 5.5V CLK, RESET, R/W, A0-A4, CS, DS, AS, SIZE
HI-Z (off state) Input Current at 2.4V/0.4V DSACK0, DSACK1, D0-D31
Output High Voltage (IOH = -400 µA)(1) DSACK0, DSACK1, D0-D31
Output Low Voltage (IOL = 5.3 mA)(1) DSACK0, DSACK1, D0-D31
Output Low Current (VOL = GND) SENSE
µA
µA
V
ITSI
20
VOH
VOL
IOL
2.4
0.5
V
500
µA
9
2119A–HIREL–04/02
ATMEL [ ATMEL ]
