欢迎访问ic37.com |
会员登录 免费注册
发布采购

5962-0051801V9X 参数 Datasheet PDF下载

5962-0051801V9X图片预览
型号: 5962-0051801V9X
PDF下载: 下载PDF文件 查看货源
内容描述: [Microcontroller, 8-Bit, 30MHz, CMOS, DIE]
分类和应用: 时钟ATM异步传输模式微控制器外围集成电路
文件页数/大小: 20 页 / 239 K
品牌: ATMEL [ ATMEL ]
 浏览型号5962-0051801V9X的Datasheet PDF文件第7页浏览型号5962-0051801V9X的Datasheet PDF文件第8页浏览型号5962-0051801V9X的Datasheet PDF文件第9页浏览型号5962-0051801V9X的Datasheet PDF文件第10页浏览型号5962-0051801V9X的Datasheet PDF文件第12页浏览型号5962-0051801V9X的Datasheet PDF文件第13页浏览型号5962-0051801V9X的Datasheet PDF文件第14页浏览型号5962-0051801V9X的Datasheet PDF文件第15页  
80C32E  
noise pulse on the ALE line may exceed 0.45V with maxi VOL peak 0.6V. A Schmitt  
Trigger use is not necessary.  
5. Under steady state (non-transient) conditions, IOL must be externally limited as fol-  
lows:  
Maximum IOL per port pin: 10 mA  
Maximum IOL per 8-bit port:  
Port 0: 26 mA  
Ports 1, 2 and 3: 15 mA  
Maximum total IOL for all output pins: 71 mA  
If IOL exceeds the test condition, VOL may exceed the related specification. Pins are  
not guaranteed to sink current greater than the listed test conditions.  
6. Operating ICC is measured with all output pins disconnected; XTAL1 driven with  
T
CLCH, TCHCL = 5 ns, VIL = VSS + 0.5 V,  
VIH = VCC - 0.5V; XTAL2 N.C.; EA = Port 0 = VCC; RST = VSS. The internal ROM runs  
the code 80 FE (label: SJMP label). ICC would be slightly higher if a crystal oscillator  
is used. Measurements are made with OTP products when possible, which is the  
worst case.  
Figure 2. ICC Test Condition, under reset  
VCC  
ICC  
VCC  
VCC  
P0  
EA  
VCC  
RST  
XTAL2  
XTAL1  
(NC)  
CLOCK  
SIGNAL  
VSS  
All other pins are disconnected.  
Figure 3. Operating ICC Test Condition  
VCC  
ICC  
VCC  
VCC  
Reset = Vss after a high pulse  
during at least 24 clock cycles  
P0  
EA  
RST  
XTAL2  
XTAL1  
(NC)  
CLOCK  
SIGNAL  
All other pins are disconnected.  
VSS  
11  
Rev. K 21-Aug-01