A25L16P Series
Figure 18. Release from Deep Power-down (RES) Instruction Sequence
S
tRES1
1
3
0
2
4
5
6
7
C
Instruction
DIO
High Impedance
DO
Deep Power-down Mode Stand-by Mode
previously in the Deep Power-down mode, though, the
transition to the Stand-by Power mode is delayed by tRES1
S
Driving Chip Select ( ) High after the 8-bit instruction byte
has been received by the device, but before the whole of the
8-bit Electronic Signature has been transmitted for the first
time (as shown in Figure 18.), still insures that the device is
put into Stand-by Power mode. If the device was not pre-
viously in the Deep Power-down mode, the transition to the
Stand-by Power mode is immediate. If the device was
,
S
and Chip Select ( ) must remain High for at least tRES1 (max),
as specified in AC Characteristics Table. Once in the
Stand-by Power mode, the device waits to be selected, so
that it can receive, decode and execute instructions.
PRELIMINARY (April, 2007, Version 0.6)
24
AMIC Technology Corp.
AMICC [ AMIC TECHNOLOGY ]
