A25L16P Series
Absolute Maximum Ratings*
*Comments
Stressing the device above the rating listed in the Absolute
Maximum Ratings" table may cause permanent damage to the
device. These are stress ratings only and operation of the
device at these or any other conditions above those indicated
in the Operating sections of this specification is not implied.
Exposure to Absolute Maximum Rating conditions for
extended periods may affect device reliability. Refer also to
the AMIC SURE Program and other relevant quality docu-
ments.
Storage Temperature (TSTG) . . . . . . . . . . . . -65°C to + 150°C
Lead Temperature during Soldering (Note 1)
D.C. Voltage on Any Pin to Ground Potential . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.6V to VCC+0.6V
Transient Voltage (<20ns) on Any Pin to Ground Potential . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -2.0V to VCC+2.0V
Supply Voltage (VCC) . . . . . . . . . . . . . . . . . . . . -0.6V to +4.0V
Electrostatic Discharge Voltage (Human Body model) (VESD)
(Note 2) . . . . . . . . . . . . . . . . . . . . . . . . . . -2000V to 2000V
Notes:
1. Compliant with JEDEC Std J-STD-020B (for small body,
Sn-Pb or Pb assembly).
2. JEDEC Std JESD22-A114A (C1=100 pF, R1=1500 Ω ,
R2=500Ω)
DC AND AC PARAMETERS
This section summarizes the operating and measurement
conditions, and the DC and AC characteristics of the device.
The parameters in the DC and AC Characteristic tables that
follow are derived from tests performed under the
Measurement Conditions summarized in the relevant tables.
Designers should check that the operating conditions in their
circuit match the measurement conditions when relying on
the quoted parameters.
Table 7. Operating Conditions
Symbol
VCC
Parameter
Min.
2.7
Max.
3.6
Unit
V
Supply Voltage
Ambient Operating Temperature
TA
–40
85
°C
Table 8. Data Retention and Endurance
Parameter
Condition
Min.
Max.
Unit
Erase/Program Cycles
At 85°C
At 85°C
100,000
Cycles per sector
Years
Data Retention
20
Note: 1. This is preliminary data
Table 9. Capacitance
Symbol
COUT
Parameter
Test Condition
VOUT = 0V
VIN = 0V
Min.
Max.
Unit
pF
Output Capacitance (DO)
8
6
CIN
Input Capacitance (other pins)
pF
Note: Sampled only, not 100% tested, at TA=25°C and a frequency of 33 MHz.
PRELIMINARY (April, 2007, Version 0.6)
27
AMIC Technology Corp.
AMICC [ AMIC TECHNOLOGY ]
