A25LQ080 Series
Deep Power-down (DP)
Executing the Deep Power-down (DP) instruction is the only
way to put the device in the lowest consumption mode (the
Deep Power-down mode). It can also be used as an extra
software protection mechanism, while the device is not in
active use, since in this mode, the device ignores all Write,
Program and Erase instructions.
The Deep Power-down mode automatically stops at
Power-down, and the device always Powers-up in the
Standby mode.
The Deep Power-down (DP) instruction is entered by driving
S
Chip Select ( ) Low, followed by the instruction code on
S
Serial Data Input (DI). Chip Select ( ) must be driven Low for
S
Driving Chip Select ( ) High deselects the device, and puts
the entire duration of the sequence. The instruction sequence
is shown in Figure 22.
the device in the Standby mode (if there is no internal cycle
currently in progress). But this mode is not the Deep
Power-down mode. The Deep Power-down mode can only be
entered by executing the Deep Power-down (DP) instruction,
to reduce the standby current (from ICC1 to ICC2, as specified in
DC Characteristics Table.).
S
Chip Select ( ) must be driven High after the eighth bit of the
instruction code has been latched in, otherwise the Deep
Power-down (DP) instruction is not executed. As soon as
S
Chip Select ( ) is driven High, it requires a delay of tDP
before the supply current is reduced to ICC2 and the Deep
Power-down mode is entered.
Any Deep Power-down (DP) instruction, while an Erase,
Program or Write Status Register cycle is in progress, is
rejected without having any effects on the cycle that is in
progress.
Once the device has entered the Deep Power-down mode, all
instructions are ignored except the Release from Deep
Power-down and Read Electronic Signature (RES) instruction.
This releases the device from this mode. The Release from
Deep Power-down and Read Electronic Signature (RES)
instruction also allows the Electronic Signature of the device
to be output on Serial Data Output (DO).
Figure 22. Deep Power-down (DP) Instruction Sequence
S
tDP
1
3
0
2
4
5
6
7
C
Instruction (B9h)
DI
Stand-by Mode
Deep Power-down Mode
(April, 2016, Version 1.0)
32
AMIC Technology Corp.
AMICC [ AMIC TECHNOLOGY ]
