Revision 1.23 - Sept 21, 2006
PowerPC 440SPe Embedded Processor
Preliminary Data Sheet
Device Characteristics
Table 7. Absolute Maximum Ratings
The absolute maximum ratings below are stress ratings only. Operation at or beyond these maximum ratings can cause
permanent damage to the device. None of the performance specification contained in this document are guaranteed when
operating at these maximum ratings.
Characteristic
Supply Voltage (Internal logic)
Supply Voltage (I/O interface, except DDR SDRAM)
Supply Voltage (PCI-X I/O)
Symbol
Value
0 to +1.6
0 to +3.6
0 to +3.6
0 to +1.6
0 to +1.6
0 to +1.6
0 to +2.7
0 to +1.95
0 to +3.6
-55 to +150
-40 to +120
Unit
V
Notes
VDD
OVDD
PxVDD
PxVDD
AxVDD
APxVDD
SVDD
SVDD
VIN
V
V
Supply Voltage (PCI-X DDR I/O)
Supply Voltages (System PLLs)
Supply Voltages (PCI-X PLLs)
Supply Voltage (DDR SDRAM logic)
Supply Voltage (DDR2 SDRAM logic)
Input Voltage (3.3V LVTTL receivers)
Storage temperature range
V
V
1
1
V
V
V
V
TSTG
°C
°C
TC
Case temperature under bias
Notes:
2
1. The analog voltages used for the on-chip PLLs can be derived from the logic voltage, but must be filtered before entering the
PPC440SPe. A separate filter, as shown below, is recommended for each voltage:
AxV , APxV
DD
PCIE_PLLVDDA & B
PCI Express
V
DD
DD
L
L – SMT ferrite bead chip, Murata BLM31A700S
Murata BLM15AG102SN1
C
C – 0.1μF ceramic
C – 1μF ceramic
2. This value is not a specification of the operational temperature range, it is a stress rating only.
58
AMCC Proprietary
AMCC [ APPLIED MICRO CIRCUITS CORPORATION ]
