Revision 5.03 – June 14, 2006
S5320 – PCI Match Maker: Signal Description
ADD-ON BUS AND S5320 CONTROL SIGNALS
Data Sheet
The following sets of signals represent the interface signals available for the user Add-On bus and S5320 control.
Table 5. Serial nvRAM Interface Signals
Signal
Type
Description
SCL
o/d-out Serial Clock. This clock provides timing for all transactions on the two-wire serial bus. The S5320 drives
this signal when performing as a serial bus master. SCL operates at the maximum allowable clock
speed and enters the high Z state when FLT# is asserted or the serial bus is inactive.
SDA
o/d
Serial Data/Address. This bi-directional signal carries serial address and data information between
nvRAMs and the S5320. This pin enters high Z state when FLT# is asserted or the serial bus is inactive.
Table 6. Direct Mailbox Access Signals
Signal
Type
Description
MDMODE
in
Mailbox Data Mode. The MD[7:0] signal pins are always inputs when this signal is high. The MD[7:0]
signal pins are defined as inputs and outputs under LOAD# control when MDMODE is low. This pin is
provided for software compatibility with the S5335. New designs should permanently connect this sig-
nal low. This signal is connected to an internal 50k Ohm pull-up.
LOAD#
MD[7:0]
in
MD[7:0] is defined as an input bus when this signal is low. The next rising edge of the ADCLK will latch
MD[7:0] data into byte three of the Add-On outgoing mailbox. When LOAD# is high and MDMODE is
low, MD[7:0] are defined as outputs displaying byte three of the PCI outgoing mailbox. This signal is
connected to an internal 50k Ohm pull-up.
t/s
Mailbox Data bus. The mailbox data registers can be directly accessed using the LOAD# and
MDMODE signals. When configured as an input, data byte three of the PCI incoming mailbox is directly
written to from these pins. When configured as an output, data byte three of the PCI outgoing mailbox
is output to these pins. All MD[7:0] signals have an internal 50k Ohm pull-up.
AMCC Confidential and Proprietary
DS1656
23
AMCC [ APPLIED MICRO CIRCUITS CORPORATION ]
