Stratix II EP2S60 DSP Development Board Data Sheet
Figure 4 shows the pin-outs for the seven-segment display.
Figure 4. Pin-Out Diagram for the Dual Seven-Segment Display
HEX_0A
HEX_1A
HEX_1G
HEX_0G
HEX_0D
HEX_0DP
HEX_1D
HEX_1DP
A/D Converters
The Stratix II EP2S60 DSP development board has two 12-bit A/D
converters that produce samples at a maximum rate of 125 mega-samples
per second (MSPS). The A/D subsystem of the board has the following
features:
■
■
The data output format from each A/D converter to the Stratix II
device is in two’s complement format.
The circuit has a wideband, AC-coupled, differential input useful for
IF sampling. The analog inputs are transformer-coupled to the A/D
converter in order to create a balanced input. To maximize
performance, two transformers are used in series. The Analog
Devices data sheet for the AD9433 device describes the detailed
operation of this circuit.
■
Any required anti-aliasing filtering can be installed externally. If
needed, users can purchase in-line SMA filters from a variety of
manufacturers, such as Mini-Circuits (www.minicircuits.com).
1
The transformer-coupled AC circuit has a lower 3-dB frequency,
of approximately 1 MHz.
The clock signal that drives the A/D converters can originate from the
Stratix II device, the external clock input, or the on-board 100-MHz
oscillator. Jumper J3 controls which clock is used for ADC A and J4 is used
20
Altera Corporation
Preliminary
ALTERA [ ALTERA CORPORATION ]
