欢迎访问ic37.com |
会员登录 免费注册
发布采购

CLK6 参数 Datasheet PDF下载

CLK6图片预览
型号: CLK6
PDF下载: 下载PDF文件 查看货源
内容描述: 的Stratix II器件手册,卷1 [Stratix II Device Handbook, Volume 1]
分类和应用:
文件页数/大小: 768 页 / 5210 K
品牌: ALTERA [ ALTERA CORPORATION ]
 浏览型号CLK6的Datasheet PDF文件第99页浏览型号CLK6的Datasheet PDF文件第100页浏览型号CLK6的Datasheet PDF文件第101页浏览型号CLK6的Datasheet PDF文件第102页浏览型号CLK6的Datasheet PDF文件第104页浏览型号CLK6的Datasheet PDF文件第105页浏览型号CLK6的Datasheet PDF文件第106页浏览型号CLK6的Datasheet PDF文件第107页  
Stratix II Architecture  
The bus-hold circuitry also pulls undriven pins away from the input  
threshold voltage where noise can cause unintended high-frequency  
switching. You can select this feature individually for each I/O pin. The  
bus-hold output drives no higher than VCCIO to prevent overdriving  
signals. If the bus-hold feature is enabled, the programmable pull-up  
option cannot be used. Disable the bus-hold feature when the I/O pin has  
been configured for differential signals.  
The bus-hold circuitry uses a resistor with a nominal resistance (RBH) of  
approximately 7 kΩ to weakly pull the signal level to the last-driven state.  
See the DC & Switching Characteristics chapter in the Stratix II Device  
Handbook, Volume 1, for the specific sustaining current driven through this  
resistor and overdrive current used to identify the next-driven input  
level. This information is provided for each VCCIO voltage level.  
The bus-hold circuitry is active only after configuration. When going into  
user mode, the bus-hold circuit captures the value on the pin present at  
the end of configuration.  
Programmable Pull-Up Resistor  
Each Stratix II device I/O pin provides an optional programmable  
pull-up resistor during user mode. If you enable this feature for an I/O  
pin, the pull-up resistor (typically 25 kΩ) weakly holds the output to the  
VCCIO level of the output pin’s bank.  
Programmable pull-up resistors are only supported on user I/O pins, and  
are not supported on dedicated configuration pins, JTAG pins or  
dedicated clock pins.  
Advanced I/O Standard Support  
Stratix II device IOEs support the following I/O standards:  
3.3-V LVTTL/LVCMOS  
2.5-V LVTTL/LVCMOS  
1.8-V LVTTL/LVCMOS  
1.5-V LVCMOS  
3.3-V PCI  
3.3-V PCI-X mode 1  
LVDS  
LVPECL (on input and output clocks only)  
HyperTransport technology  
Differential 1.5-V HSTL Class I and II  
Differential 1.8-V HSTL Class I and II  
Differential SSTL-18 Class I and II  
Differential SSTL-2 Class I and II  
Altera Corporation  
May 2007  
2–85  
Stratix II Device Handbook, Volume 1  
 复制成功!