AS4C128M16D3A-12BIN
z DLL on/off switching procedure
DDR3 DLL-off mode is entered by setting MR1 bit A0 to “1”; this will disable the DLL for subsequent operation until
A0 bit set back to “0”.
z DLL “on” to DLL “off” Procedure
To switch from DLL “on” to DLL “off” requires the frequency to be changed during Self-Refresh outlined in the
following procedure:
1. Starting from Idle state (all banks pre-charged, all timing fulfilled, and DRAMs On-die Termination resistors,
RTT, must be in high impedance state before MRS to MR1 to disable the DLL).
2. Set MR1 Bit A0 to “1” to disable the DLL.
3. Wait tMOD.
4. Enter Self Refresh Mode; wait until (tCKSRE) satisfied.
5. Change frequency, in guidance with “Input Clock Frequency Change” section.
6. Wait until a stable clock is available for at least (tCKSRX) at DRAM inputs.
7. Starting with the Self Refresh Exit command, CKE must continuously be registered HIGH until all tMOD
timings from any MRS command are satisfied. In addition, if any ODT features were enabled in the mode
registers when Self Refresh mode was entered, the ODT signal must continuously be registered LOW until all
tMOD timings from any MRS command are satisfied. If both ODT features were disabled in the mode registers
when Self Refresh mode was entered, ODT signal can be registered LOW or HIGH.
8. Wait tXS, and then set Mode Registers with appropriate values (especially an update of CL, CWL, and WR
may be necessary. A ZQCL command may also be issued after tXS).
9. Wait for tMOD, and then DRAM is ready for next command.
Figure 10. DLL Switch Sequence from DLL-on to DLL-off
T0
T1
Ta0
Ta1
Tb0
Tc0
Td0
Td1
Te0
Te1
Tf0
CK#
CK
Notes 8
Notes 8
VALID
VALID
CKE
Notes 2
Notes 3
Notes 6
Notes 7
MRS
NOP
SRE
NOP
SRX
NOP
MRS
NOP
COMMAND
Notes 5
Notes 1
Notes 4
tMOD
tCKSRE
tCKSRX
tXS
tMOD
Notes 8
VALID
tCKESR
ODT
ODT: Static LOW in case RTT_Nom and RTT_WR is enabled, otherwise static Low or High
NOTES:
TIME BREAK
Don't Care
1. Starting with Idle State, RTT in Hi-Z state
2. Disable DLL by setting MR1 Bit A0 to 1
3. Enter SR
4. Change Frequency
5. Clock must be stable tCKSRX
6. Exit SR
7. Update Mode registers with DLL off parameters setting
8. Any valid command
Confidential
-32/83-
Rev. 1.0 May 2016