Switching Specifications (AC)
Over recommended operating conditions unless otherwise specified.
Parameter
V
IN
to V
OUT
Signal Delay (50 – 10%)
V
IN
to V
OUT
Signal Delay (50 – 50%)
V
IN
to V
OUT
Signal Delay (50 – 90%)
V
OUT
Rise Time (10 – 90%)
V
OUT
Fall Time (10 – 90%)
V
OUT
Bandwidth (-3 dB)
V
OUT
Noise
Common Mode Transient
Immunity
Symbol Min.
t
PD10
t
PD50
t
PD90
t
R
t
F
BW
N
OUT
CMTI
10
50
Typ.
2.2
3.4
5.2
3.0
3.2
100
31.5
15
Max.
4
5
9.9
7
7
Units
µs
µs
µs
µs
µs
kHz
V
IN+
= 200 mV
pk-pk
T
A
= 25°C, V
CM
= 1000 V
14
Test Conditions
V
IN+
= 0 mV to 200 mV step
Fig. Note
13
mVrms V
IN+
= 0 V
kV/µs
15
Package Characteristics
Parameter
Input-Output Momentary
Withstand Voltage
Input-Output Resistance
Input-Output Capacitance
Symbol
V
ISO
R
I-O
C
I-O
Min.
3750
>10
9
1.4
Typ.
Max.
Units
V
rms
Ω
pF
Test Conditions
T
A
= 25°C, RH < 50%
V
I-O
= 500 V
Freq = 1 MHz
Fig.
Note
6
Notes:
General Note: Typical values were taken from a sample of nominal units operating at nominal conditions (V
DD1
= V
DD2
= 5 V, V
REF
= 4.0 V, Temperature =
25°C) unless otherwise stated. Nominal plots shown from Figure 1 to 11 represented the drift of these nominal units from their nominal operating
conditions.
1. Input Offset Voltage is defined as the DC Input Voltage required to obtain an output voltage of V
REF
/2.
2. Gain is defined as the slope of the best-fit line of the output voltage vs. the differential input voltage (V
IN+
- V
IN-
) over the specified input range. Gain
is derived from V
REF
/512 mV; e.g. V
REF
= 5.0, gain will be 9.77 V/V.
3. Nonlinearity is defined as half of the peak-to-peak output deviation from the best-fit gain line, expressed as a percentage of the full-scale output
voltage range.
4. NL
200
is the nonlinearity specified over an input voltage range of ±200 mV.
5. NL
100
is the nonlinearity specified over an input voltage range of ±100 mV.
6. In accordance with UL1577, each optocoupler is proof tested by applying an insulation test voltage •4500 Vrms for 1 second (leakage detection current
limit, I
I-O
< 5 µA). This test is performed before the 100% production test for the partial discharge (method b) shown in
IEC/EN/DIN EN 60747-5-2 Insulation Characteristic Table, if applicable.
7. CMRR is defined as the ratio of the differential signal gain (signal applied differentially between pins 2 and 3) to the common-mode gain (input pins
tied together and the signal applied to both inputs at the same time), expressed in dB.
8
AGILENT [ AGILENT TECHNOLOGIES, LTD. ]
