A14100A Timing Characteristics
(Worst-Case Military Conditions, VCC = 4.5V, TJ = 125°C)
‘–1’ Speed
‘Std’ Speed
Parameter
Description
Min.
Max.
Min.
Max.
Units
Logic Module Propagation Delays1
tPD
Internal Array Module
Sequential Clock to Q
Asynchronous Clear to Q
3.0
3.0
3.0
3.5
3.5
3.5
ns
ns
ns
tCO
tCLR
Logic Module Predicted Routing Delays2
tRD1
tRD2
tRD3
tRD4
tRD8
FO=1 Routing Delay
FO=2 Routing Delay
FO=3 Routing Delay
FO=4 Routing Delay
FO=8 Routing Delay
1.3
1.9
2.1
2.6
4.2
1.5
2.1
2.5
2.9
4.9
ns
ns
ns
ns
ns
Logic Module Sequential Timing
tSUD
Flip-Flop (Latch) Data Input Setup
1.0
0.6
1.0
0.6
4.8
4.8
9.9
1.0
0.6
1.0
0.6
5.6
5.6
11.6
ns
ns
tHD
Flip-Flop (Latch) Data Input Hold
Flip-Flop (Latch) Enable Setup
Flip-Flop (Latch) Enable Hold
Asynchronous Pulse Width
Flip-Flop Clock Pulse Width
Flip-Flop Clock Input Period
Flip-Flop Clock Frequency
tSUENA
tHENA
tWASYN
tWCLKA
tA
ns
ns
ns
ns
ns
fMAX
100
85
MHz
Input Module Propagation Delays
tINY
Input Data Pad to Y
4.2
7.0
7.0
7.0
7.0
4.9
8.2
8.2
8.2
8.2
ns
ns
ns
ns
ns
tICKY
Input Reg IOCLK Pad to Y
Output Reg IOCLK Pad to Y
Input Asynchronous Clear to Y
Output Asynchronous Clear to Y
tOCKY
tICLRY
tOCLRY
Input Module Predicted Routing Delays2, 3
tIRD1
tIRD2
tIRD3
tIRD4
tIRD8
Notes:
FO=1 Routing Delay
FO=2 Routing Delay
FO=3 Routing Delay
FO=4 Routing Delay
FO=8 Routing Delay
1.3
1.9
2.1
2.6
4.2
1.5
2.1
2.5
2.9
4.9
ns
ns
ns
ns
ns
1. For dual-module macros, use tPD + tRD1 + tPDn , tCO + tRD1 + tPDn , or tPD1 + tRD1 + tSUD , whichever is appropriate.
2. Routing delays are for typical designs across worst-case operating conditions. These parameters should be used for estimating device
performance. Post-route timing analysis or simulation is required to determine actual worst-case performance. Post-route timing is
based on actual routing delay measurements performed on the device prior to shipment.
3. Optimization techniques may further reduce delays by 0 to 4 ns.
44
ACTEL [ Actel Corporation ]
