MIL-PRF-38535K
APPENDIX A
A.6 NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.)
A.6.1 Intended use. Microcircuits conforming to this appendix are intended for use for Government microcircuit
application and logistic purposes. For maximum cost effectiveness while maintaining essential quality and reliability
requirements, it is recommended that, for initial acquisitions for original equipment complements, the device class
appropriate to the need of the application (see A.3.4) be acquired.
A.6.2 Acquisition requirements. Acquisition documents should specify the following:
a.
b.
c.
d.
e.
Title, number, and date of the specification.
PIN and compliance identification (if applicable).
Test data to be furnished.
Packaging Requirements (see A.5).
Requirement for radiation hardness assurance testing (see A.4.4.2.5 and A.4.5.6).
A.6.2.1 Lead finish designator. For Government logistic support, the A lead finish will be ordered and supplied to
the end user when X is used in place of the A, B, C, D, or E lead finish designator. If the device type is not available
with lead finish A, the same PIN will be ordered except that B, C, D, or E will be used as the lead finish designator
depending upon which is available.
101
ACTEL [ Actel Corporation ]
