(OHFWULFDO#,QVWDOODWLRQ##7#0#4
(/(&75,&$/#,167$//$7,21
Read the Safety Information at the front of the manual before proceeding.
:,5,1*#*8,'(/,1(6#)25#(0&
The 601 series has been designed to comply with the European Community Directive
89/336/EEC on EMC. In particular the 601 meets the given generic emission and
immunity standards specified in table 2.2 when suitably cubicle mounted and when
the internal RFI filter option is fitted.
The following wiring guidelines must be followed to prevent interference with other
electrical equipment.
8VLQJ#&DJH#&ODPS#7HUPLQDOV
&RQWURO#DQG#3RZHU
To wire the control terminals or the power terminals (see figure 4-1):
•
•
Remove the terminal cover as shown in figure 1.1.
Insert a flat-bladed screwdriver (size 3.5 mm max.)
inside the smallest hole.
•
•
Lever the screwdriver keeping it firmly pressed into
the hole. The cage will open.
Insert the stripped wire (5mm to 6mm/0.22in.) or
wire crimp inside the cage keeping the screwdriver
in position.
•
Remove the screwdriver. Note the cage provides the
correct force for a secure connection.
)LJXUH#714
'\QDPLF#%UDNH#7HUPLQDO#+7339#RQO\,
•
•
•
Insert a flat-bladed screwdriver (size 3.5 mm max.)
inside the hole as shown in figure 4.2.
Press the screwdriver down, keeping it firml
pressed into the hole. The cage will open.
5HDU#RI#WRS#FRYHU
Insert the stripped wire (5mm to 6mm/0.22in.) or
wire crimp inside the cage keeping the screwdriver
in position.
DBR1
DBR2
•
Remove the screwdriver. Note the cage provides the
correct force for a secure connection.
)LJXUH#715
934#0##+$79784;#
(1*/,6+
ETC [ ETC ]
