PIC16F87X
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial and
0°C ≤ TA ≤ +70°C for commercial
DC CHARACTERISTICS
Operating voltage VDD range as described in DC spec Section 15.1 and
Section 15.2.
Param
No.
Characteristic
Sym
Min Typ† Max Units
Conditions
Output High Voltage
D090
D092
I/O ports (Note 3)
VOH VDD - 0.7
VDD - 0.7
-
-
-
-
V
V
V
IOH = -3.0 mA, VDD = 4.5V,
-40°C to +85°C
IOH = -1.3 mA, VDD = 4.5V,
-40°C to +85°C
OSC2/CLKOUT (RC osc config)
D150* Open-Drain High Voltage
VOD
-
-
-
-
8.5
RA4 pin
Capacitive Loading Specs on
Output Pins
D100
OSC2 pin
COSC2
-
-
15
pF In XT, HS and LP modes when exter-
nal clock is used to drive OSC1.
D101
D102
All I/O pins and OSC2 (in RC
CIO
CB
-
-
-
-
50
400
pF
pF
mode) SCL, SDA in I2C mode
Data EEPROM Memory
Endurance
D120
D121
ED
100K
-
-
-
E/W 25°C at 5V
V
VDD for read/write
VDRW Vmin
5.5
Using EECON to read/write
Vmin = min operating voltage
D122
Erase/write cycle time
Program FLASH Memory
Endurance
TDEW
-
4
8
ms
D130
D131
EP
VPR
1000
Vmin
Vmin
-
-
-
-
E/W 25°C at 5V
V
V
VDD for read
5.5
5.5
Vmin = min operating voltage
using EECON to read/write,
Vmin = min operating voltage
D132a VDD for erase/write
D133 Erase/Write cycle time
TPEW
-
4
8
ms
Legend: * These parameters are characterized but not tested.
† Data in "Typ" column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: In RC oscillator configuration, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the
PIC16F87X be driven with external clock in RC mode.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified levels
represent normal operating conditions. Higher leakage current may be measured at different input voltages.
3: Negative current is defined as current sourced by the pin.
1999 Microchip Technology Inc.
DS30292B-page 157
ETC [ ETC ]
