Product specification
7
9
SERIES
0402
RC
Chip Resistor Surface Mount
TEST
TEST METHOD
IEC 60068-2-21
PROCEDURE
REQUIREMENTS
Board Flex/
Bending
Chips mounted on a 90mm glass epoxy resin
PCB (FR4)
±(1.0%+0.05 Ω) for 1%, 5% tol.
<50 mΩ for Jumper
5 mm bending
No visible damage
Bending time: 60±5 seconds
IEC 60068-2-1
Low
Temperature
Operation
The resistor shall be subjected to a DC rated
voltage for 1.5 h-on, 0.5 h-off, at -55±3 °C
±(0.5%+0.05 Ω) for 1% tol.
±(1.0%+0.05 Ω) for 5% tol.
No visible damage
This constitutes shall be repeated for 96 hours
However the applied voltage shall not exceed
the maximum operating voltage
IEC 60115-1 4.6
IEC 60115-1 4.7
Insulation
Resistance
Rated continuous overload voltage (RCOV)
for 1 minute
≥10 GΩ
RC0402
Type
Voltage (DC)
100 V
Dielectric
Withstand
Voltage
Maximum voltage (Vrms) applied for 1 minute
No breakdown or flashover
RC0402
Type
Voltage (AC)
100 Vrms
IPC/JEDEC J-STD-020D
IEC 60115-1 4.12
Resistance to
Solvent
lsopropylalcohol (C3H7OH) followed by
brushing
No smeared
Noise
Maximum voltage (Vrms) applied
Value
Resistors range
R < 100 Ω
10 dB
20 dB
30 dB
40 dB
46 dB
48 dB
100 Ω ≤ R < 1 KΩ
1 KΩ ≤ R < 10 KΩ
10 KΩ ≤ R < 100 KΩ
100 KΩ ≤ R < 1 MΩ
1 MΩ ≤ R ≤ 22 MΩ
IEC 60115-1 4.21
Humidity
Steady state for 1000 hours at 40 °C / 95% R.H.
RCWV applied for 1.5 hours on and
0.5 hour off
±(1.0%+0.05 Ω) for 1% tol.
±(2.0%+0.05 Ω) for 5% tol.
<100 mΩ for Jumper
www.yageo.com
Jan 05, 2011 V.6
YAGEO [ YAGEO CORPORATION ]
