R
MultiPRO Desktop Tool
Physical Description
X-Ref Target - Figure 3
Power
Switch
+5VDC External Power
Supply
Cable
INIT
NC
DIN
DONE
CCLK
PROG
Vref
Serial/JTAG/SPI
LED
S/JTAG
STATUS
NC
NC
TDI
TDO
TCK
TMS
Vref
Gnd
Gnd
Gnd
Gnd
Gnd
Gnd
Gnd
Vref
NC
Gnd
Gnd
Gnd
Gnd
Gnd
Gnd
Gnd
Gnd
Gnd
Gnd
Gnd
Gnd
Gnd
Gnd
Gnd
Power Port
14-pin
Serial/JTAG/SPI
Ribbon Cable Connector
Serial
MultiPRO
Desktop Tool
IEEE-1284-C
Parallel Port
Model DLC8
Power 5V
0.3A
Serial
MP -
1 2
3
4 5
Made in U.S.A.
SelectMAP
JTAG
Adapter Port
CS0
CS1
CS2
PROG
INIT
DONE
BUSY
RDWR
CCLK
D0
D1
D2
D3
D4
D5
D6
D7
34-pin SelectMAP
Ribbon Cable Connector
SMAP
STATUS
SelectMAP
LED
Quick Connect IEEE 1284
Parallel Port Cable
HW-MP-PQ208
ACTIVE
20-Pin Keyed
DIN Connector
Adapter's red
"ACTIVE" LED
Socket
1
PIN
MultiPRO PQ208 Adapter
for CoolRunner
TM
II
-
ds114_04_062907
Figure 3:
MultiPRO Connector Descriptions
External Power Supply
The MultiPRO Desktop Tool requires an external +5V DC
power supply. The power supply is a CE approved switching
regulator that operates from an AC outlet and connects to
the MultiPRO tool using a 5.5 mm x 2.1 mm plug (Figure
4).
A power switch on the MultiPRO case is provided as a
convenience so that all other cables can remain attached.
The standard MultiPRO power supply (CUI Inc.
#DTS050400UC-P5P-KH) is capable of operating from
100VAC to 240VAC at 47 Hz to 63 Hz. The +5V DC output
is rated for 4A. This power supply can also be used with the
Xilinx Parallel Cable IV (configuration cable) instead of the
supplied Power Splitter Cable.
X-Ref Target - Figure 4
Figure 4:
Standard External +5V DC Power Brick
DS114 (v1.9) February 8, 2008
Product Specification
3
XILINX [ XILINX, INC ]
