Platform Cable USB II
Target Interface Connectors
Mating connectors for attachment of the high-performance ribbon cable to a target system are available in both through-hole
and surface mount configurations (Figure 14). Shrouded and keyed versions should always be used to guarantee proper
2
orientation when inserting the cable. The connector requires only 105 mm of board space.
The target system voltage applied to pin 2 of this connector is used as a power source for the output buffers that drive the
output pins (see Target Interface Reference Voltage and Signals, page 19).
Table 5, page 14 provides some third-party sources for mating connectors that are compatible with the Platform Cable USB
II ribbon cable.
X-Ref Target - Figure 14
6.30 mm
7.59 mm
2.00 mm
Slave
Serial
12.00 mm
SPI
WP
JTAG
INIT
HALT 14
13 PGND
11 GND
NC
MOSI
MISO
SCK
SS
NC
DIN
NC 12
TDI 10
2.00 mm
TYP.
9
7
5
3
1
GND
GND
GND
GND
16.66 mm
DONE
CCLK
PROG
Vref
TDO
TCK
TMS
Vref
8
6
4
2
Vref
0.50 mm
Figure 14: Target Interface Connector Dimensions and Signal Assignments
Table 5: Mating Connectors for 2 mm pitch, 14-Conductor Ribbon Cable
DS593_14_012508
SMT,
Vertical
Through-Hole,
Vertical
Through-Hole,
Right Angle
Manufacturer(1)
Web Site
Molex
FCI
87832-1420
98424-G52-14
2475-14G2
87831-1420
98414-G06-14
2422-14G2
87833-1420
98464-G61-14
2401R-G2-14
www.molex.com
www.fciconnect.com
www.commcon.com
Comm Con Connectors
Notes:
1. Some manufacturer pin assignments do not conform to Xilinx pin assignments. Please refer to the manufacturer’s data sheet for more
information.
2. Additional ribbon cables can be purchased separately from the Xilinx Online Store.
DS593 (v1.2.1) March 17, 2011
www.xilinx.com
14
XILINX [ XILINX, INC ]
