Production Data
WM8321
23.2.2 THERMAL INTERRUPTS
The primary TEMP_INT interrupt comprises a single secondary interrupt as described in Section 26.
The secondary interrupt bit is defined in Table 66.
The secondary interrupt can be masked. When the mask bit is set, the corresponding interrupt event
is masked and does not trigger a TEMP_INT interrupt. The secondary interrupt bit in R16401 (4011h)
is valid regardless of whether the mask bit is set. The secondary interrupt is masked by default.
ADDRESS
BIT
LABEL
DESCRIPTION
Thermal Warning interrupt
(Rising and Falling Edge triggered)
Note: Cleared when a ‘1’ is written.
Interrupt mask.
R16401 (4011h)
TEMP_THW_CINT
1
Interrupt Status
1
R16410 (4019h)
IM_TEMP_THW_CINT
1
Interrupt Status
1 Mask
0 = Do not mask interrupt.
1 = Mask interrupt.
Default value is 1 (masked)
Table 66 Thermal Interrupts
23.2.3 GPIO INTERRUPTS
The primary GP_INT interrupt comprises sixteen secondary interrupts as described in Section 21.4.
The secondary interrupt bits are defined in Table 67.
Each of the secondary interrupts can be masked. When a mask bit is set, the corresponding interrupt
event is masked and does not trigger a GP_INT interrupt. The secondary interrupt bits in R16405
(4015h) are valid regardless of whether the mask bit is set. The secondary interrupts are all masked
by default.
ADDRESS
BIT
LABEL
GPn_EINT
DESCRIPTION
GPIO interrupt.
R16405 (4015h)
15:0
Interrupt Status
5
(Trigger is controlled by
GPn_INT_MODE)
Note: Cleared when a ‘1’ is written.
Interrupt mask.
R16413
(401Dh)
IM_GPn_EINT
15:0
0 = Do not mask interrupt.
1 = Mask interrupt.
Interrupt Status
5 Mask
Default value is 1 (masked)
Note: n is a number between 1 and 12 that identifies the individual GPIO.
Table 67 GPIO Interrupts
23.2.4 ON PIN INTERRUPTS
The primary ON_PIN_INT interrupt comprises a single secondary interrupt as described in
Section 11.6. The secondary interrupt bit is defined in Table 68.
The secondary interrupt can be masked. When the mask bit is set, the corresponding interrupt event
is masked and does not trigger an ON_PIN_INT interrupt. The secondary interrupt bit in R16401
(4011h) is valid regardless of whether the mask bit is set. The secondary interrupt is masked by
default.
ADDRESS
BIT
LABEL
ON_PIN_CINT
DESCRIPTION
ON pin interrupt.
R16401 (4011h)
12
Interrupt Status
1
(Rising and Falling Edge triggered)
Note: Cleared when a ‘1’ is written.
Interrupt mask.
R16409 (4019h)
IM_ON_PIN_CINT
12
Interrupt Status
1 Mask
0 = Do not mask interrupt.
1 = Mask interrupt.
Default value is 1 (masked)
Table 68 ON Pin Interrupt
PD, February 2012, Rev 4.0
123
w
WOLFSON [ WOLFSON MICROELECTRONICS PLC ]
