W83697HF/F
Bit 7: This bit reflects the complement of the Busy input.
Bit 6: This bit reflects the nAck input.
Bit 5: This bit reflects the PError input.
Bit 4: This bit reflects the Select input.
Bit 3: This bit reflects the nFault input.
Bit 2-0: These three bits are not implemented and are always logic one during a read.
6.3.4 Device Control Register (DCR)
The bit definitions are as follows:
7
6
5
4
3
2
1
0
1
1
strobe
autofd
nInit
SelectIn
ackIntEn
Direction
Bit 6, 7: These two bits are logic one during a read and cannot be written.
Bit 5: This bit has no effect and the direction is always out if mode = 000 or mode = 010. Direction is
valid in all other modes.
0
1
the parallel port is in output mode.
the parallel port is in input mode.
Bit 4: Interrupt request enable. When this bit is set to a high level, it may be used to enable interrupt
requests from the parallel port to the CPU due to a low to high transition on the input.
ACK#
Bit 3: This bit is inverted and output to the
output.
SLIN#
The printer is not selected.
The printer is selected.
0
1
Bit 2: This bit is output to the
output.
INIT#
Bit 1: This bit is inverted and output to the
Bit 0: This bit is inverted and output to the
output.
output.
AFD#
STB#
Publication Release Date: Feb. 2002
Revision 0.70
- 72 -
WINBOND [ WINBOND ]
