W83627HF/ F/ HG/ G
FAN IN/OUT and BEEP Control Register- Index 4Dh
Register Location：
Power on Default Value：
Attribute：
4Dh
15h
Read/Write
8 bits
Size：
7
6
5
4
3
2
1
0
FANINC1
FANOPV1
FANINC2
FANOPV2
FANINC3
FANOPV3
RESERVED
DIS_ABN
Bit 7： Disable power-on abnormal the monitor voltage including V-Core A and +3.3V. If these voltage
exceed the limit value, the pin （Open Drain） of BEEP will drives 300Hz and 600Hz frquency
signal. Write 1, the frequency will be disabled. Default is 0. After power on, the system should
set 1 to this bit to 1 in order to disable BEEP.
Bit 6： Reserved.
Bit 5： FAN 3 output value if FANINC3 sets to 0. Write 1, then pin 18 always generate logic high sig-
nal. Write 0, pin 18 always generates logic low signal. This bit default 0.
Bit 4： FAN 3 Input Control. Set to 1, pin 18 acts as FAN clock input, which is default value. Set to 0,
this pin 18 acts as FAN control signal and the output value of FAN control is set by this register
bit 5.
Bit 3： FAN 2 output value if FANINC2 sets to 0. Write 1, then pin 19 always generate logic high sig-
nal. Write 0, pin 19 always generates logic low signal. This bit default 0.
Bit 2： FAN 2 Input Control. Set to 1, pin 19 acts as FAN clock input, which is default value. Set to 0,
this pin 19 acts as FAN control signal and the output value of FAN control is set by this register
bit 3.
Bit 1： FAN 1 output value if FANINC1 sets to 0. Write 1, then pin 20 always generate logic high sig-
nal. Write 0, pin 20 always generates logic low signal. This bit default 0.
Bit 0： FAN 1 Input Control. Set to 1, pin 20 acts as FAN clock input, which is default value. Set to 0,
this pin 20 acts as FAN control signal and the output value of FAN control is set by this register
bit 1.
- 54 -
WINBOND [ WINBOND ]
