VITESSE
SEMICONDUCTOR CORPORATION
Data Sheet
VSC8021/VSC8022
VSC8022
2.5Gb/s SONET-Compatible
8-Bit MUX/DEMUX Chipset
The VSC8022 contains both a 1:8 demultiplexer and SONET frame recovery circuitry. The 1:8 demultiplexer
accepts a serial data input (DI,
DIN)
at rates up to 2.5Gb/s and converts it into 8 parallel differential ECL data outputs
(D1-D8,
D1N-D8N)
at rates up to 312.5Mb/s. Valid parallel data outputs are indicated by the divide by 8 differential
clock outputs
BYCKO, BYCKON.
The VSC8022 also contains a SONET frame recovery circuit. The frame recovery circuits are enabled by a fall-
ing edge on the
OOFN
ECL input when the
FDIS
input is low. Once enabled, the frame recovery circuit starts look-
ing for the SONET framing sequence. Once the frame is detected, the word boundary is realigned, a confirmation
signal is sent off-chip through the
FP
ECL output and the frame recovery circuits are disabled. While the frame
aligner is hunting for the frame,
BYCKO, BYCKON
and parallel data are invalid.
Figure 2: VSC8022 Block Diagram
D1
D1N
Serial Data In
DI
DIN
1:8
Demultiplexer
D8
D8N
Parallel
Data Outputs
High Speed
Clock Inputs
CLKI
CLKIN
Timing
Generator
Frame Recovery Disable —
FDIS
Frame Recovery Clock —
OOFN
SONET
Frame
Detection &
Recovery
FP
— Frame Detection Signal
BYCKO
BYCKON
Byte Clock Out
Frame recovery circuits are disabled by frame detection (resulting in FP) or by a falling edge on the OOFN
input while FDIS is high.
G52028-0, Rev 4.1
05/25/01
©
VITESSE
SEMICONDUCTOR CORPORATION
• 741 Calle Plano • Camarillo, CA 93012
Tel: (800) VITESSE • FAX: (805) 987-5896 • Email: prodinfo@vitesse.com
Internet: www.vitesse.com
Page 3