TMCM-1070 Hardware Manual • Hardware Version V1.00 | Document Revision V1.00 • 2016-Sept-16
10 / 23
4.2 I/O Connector
Pin no. Pin name Description
1
2
3
4
5
6
7
GND
V+
Supply ground connection, also used for USB serial converter ground connection
Supply voltage (V DD) +9V to +28V DC
DIR
Optically isolated direction input of S/D interface
Optically isolated step input of S/D interface
Optically isolated enable input of motor driver H-bridges
Optically isolated chopper mode selection input
STEP
EN
CHOP
COMM
Opto-coupler common anode or cathode, connect to ground or VCCIO (3.3V to
24V)
8
9
RXD
TXD
TTL-level UART receive line, use with USB serial converter TXD line to connect to
PC
TTL-level UART transmit line, use with USB serial converter RXD line to connect to
PC
Table 5: I/O connector pinning
Supply Voltage Buffering / Add External Power Supply Capacitors
A sufficiently buffered power supply or an external electrolyte capacitor
connected between V+ and GND is recommended for stable operation.
It is recommended to connect an electrolytic capacitor of significant size to the
power supply lines next to the TMCM-1070.
NOTICE
Rule of thumb for size of electrolytic capacitor: C = 1000µF ∗ ISUP P LY
A
The PD42-1070 comes with approximately 40 F of onboard ceramic capacitors.
µ
There is no reverse polarity protection on the supply input!
The module will short any reversed supply voltage and board electronics will get
damaged.
NOTICE
NOTICE
Power Up Sequence
The TMCM-1070 must be powered up with disabled driver stage only. Depending
on your configuration the EN input should be logically OFF. For example, if COMM
input is connected to 3.3V to 24V, the EN input must be 0V. If common ground or
0V level is connected to COMM input, the EN input must have high level.
©2016 TRINAMIC Motion Control GmbH & Co. KG, Hamburg, Germany
Terms of delivery and rights to technical change reserved.
Download newest version at www.trinamic.com
Read entire documentation.