TS8GSSD25S-S
TS16GSSD25S-S/M
TS32GSSD25S-S/M
TS64GSSD25S-S/M
TS128GSSD25S-M
TS192GSSD25S-M
2.5” Solid State Disk
STANDBY (E2h)
This command causes the device to set BSY, enter the Sleep mode (which corresponds to the ATA “Standby” Mode),
clear BSY and return the interrupt immediately.
STANDBY IMMEDIATE (E0h)
This command causes the drive to set BSY, enter the Sleep mode (which corresponds to the ATA “Standby” Mode), clear
BSY and return the interrupt immediately.
WRITE BUFFER (E8h)
This command enables the host to write the contents of one 512-byte block of data to the device’s buffer.
WRITE DMA (CAh)
Write data to sectors during Ultra DMA and Multiword DMA transfer. Use the SET FEATURES command to specify the
mode value.
WRITE DMA EXT (35h)
48-bit feature set mandatory command. Write data to sectors during Ultra DMA and Multiword DMA transfer. Use the SET
FEATURES command to specify the mode value.
WRITE DMA FUA EXT (3Dh)
48-bit feature set mandatory command. This command provides the same function as the WRITE DMA EXT command
except that regardless of whether volatile and/or non-volatile write caching in the device is enabled or not, the user data
shall be written to non-volatile media before command completion is reported.
WRITE FPDMA QUEUED (61h)
NCQ feature set mandatory 48-bit command. This command causes data to be transferred from the host to the device.
WRITE MULTIPLE (C5h)
This command is similar to the Write Sectors command. Interrupts are not presented on each sector, but on the transfer of
a block which contains the number of sectors defined by Set Multiple command.
36
Transcend Information Inc.
V2.4
TRANSCEND [ TRANSCEND INFORMATION. INC. ]
