Functional Overview
15
IPTR
R/W-1FF
7
6
5
4
3
2
1
0
IPTR
MP/MC
OVLY
R/W-0
AVIS
R/W-0
DROM
R/W-0
CLKOFF
R/W-0
SMUL
R/W-0
SST
MP/MC Pin
R/W-0
LEGEND: R = Read, W = Write, n = value after reset
Figure 3−6. Processor Mode Status (PMST) Register
Table 3−2. Processor Mode Status (PMST) Register Bit Fields
BIT
RESET
FUNCTION
VALUE
NO.
NAME
Interrupt vector pointer. The 9-bit IPTR field points to the 128-word program page where the interrupt
vectors reside. The interrupt vectors can be remapped to RAM for boot-loaded operations. At reset, these
bits are all set to 1; the reset vector always resides at address FF80h in program memory space. The
RESET instruction does not affect this field.
15−7
IPTR
1FFh
Microprocessor/microcomputer mode. MP/MC enables/disables the on-chip ROM to be addressable in
program memory space.
-
-
MP/MC = 0: The on-chip ROM is enabled and addressable.
MP/MC = 1: The on-chip ROM is not available.
MP/MC
pin
6
5
MP/MC
OVLY
MP/MC is set to the value corresponding to the logic level on the MP/MC pin when sampled at reset. This
pin is not sampled again until the next reset. The RESET instruction does not affect this bit. This bit can
also be set or cleared by software.
RAM overlay. OVLY enables on-chip dual-access data RAM blocks to be mapped into program space.
The values for the OVLY bit are:
-
-
OVLY = 0: The on-chip RAM is addressable in data space but not in program space.
0
OVLY = 1: The on-chip RAM is mapped into program space and data space. Data page 0 (addresses
0h to 7Fh), however, is not mapped into program space.
Address visibility mode. AVIS enables/disables the internal program address to be visible at the
address pins.
-
AVIS = 0: The external address lines do not change with the internal program address. Control and
data lines are not affected and the address bus is driven with the last address on the bus.
4
3
AVIS
0
0
-
AVIS = 1: This mode allows the internal program address to appear at the pins of the 5407/5404 so
that the internal program address can be traced. Also, it allows the interrupt vector to be decoded
in conjunction with IACK when the interrupt vectors reside on on-chip memory.
Data ROM. DROM enables on-chip ROM to be mapped into data space. The DROM bit values are:
-
-
DROM = 0: The on-chip ROM is not mapped into data space.
DROM
DROM = 1: A portion of the on-chip ROM is not mapped into data space.
The SWSM bit of the SWCR defines a multiplication factor of 1 or 2 for the base number of wait states.
CLOCKOUT off. When the CLKOFF bit is 1, the output of CLKOUT is disabled and remains at a high
level.
2
1
0
CLKOFF
SMUL
SST
0
Saturation on multiplication. When SMUL = 1, saturation of a multiplication result occurs before
performing the accumulation in a MAC of MAS instruction. The SMUL bit applies only when OVM = 1
and FRCT = 1.
N/A
N/A
Saturation on store. When SST = 1, saturation of the data from the accumulator is enabled before
storing in memory. The saturation is performed after the shift operation.
29
November 2001 − Revised April 2004
SPRS007D
TI [ TEXAS INSTRUMENTS ]
