TL16C752B
3.3-V DUAL UART WITH 64-BYTE FIFO
SLLS405A – DECEMBER 1999 – REVISED AUGUST 2000
PRINCIPLES OF OPERATION
interrupt identification register (IIR) (continued)
The interrupt priority list is illustrated in Table 16.
Table 16. Interrupt Priority List
PRIORITY
LEVEL
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
INTERRUPT SOURCE
Receiver line status error
1
2
2
3
4
5
6
0
0
0
0
0
0
1
0
0
0
0
0
1
0
0
1
0
0
0
0
0
1
1
1
0
0
0
0
1
0
0
1
0
0
0
0
0
0
0
0
0
0
Receiver timeout interrupt
RHR interrupt
THR interrupt
Modem interrupt
Received Xoff signal/special character
CTS, RTS change of state from active (low) to inactive (high).
enhanced feature register (EFR)
This8-bitregisterenablesordisablestheenhancedfeaturesoftheUART. Table17showstheenhancedfeature
register bit settings.
Table 17. Enhanced Feature Register (EFR) Bit Settings
BIT NO.
BIT SETTINGS
3:0
4
Combinations of software flow control can be selected by programming bit 3–bit 0. See Table 1.
Enhanced functions enable bit
0 = Disables enhanced functions and writing to IER bits 4–7, FCR bits 4–5, MCR bits 5–7.
1 = Enables the enhanced function IER bits 4–7, FCR bit 4–5, and MCR bits 5–7 can be modified, i.e., this bit is therefore a
write enable.
5
6
0 = Normal operation
1 = Special character detect. Received data is compared with Xoff-2 data. If a match occurs the received data is transferred to
FIFO and IIR bit 4 is set to 1 to indicate a special character has been detected.
RTS flow control enable bit
0 = Normal operation
1 = RTS flow control is enabled i.e., RTS pin goes high when the receiver FIFO HALT trigger level TCR[3:0] is reached, and
goes low when the receiver FIFO RESTORE transmission trigger level TCR[7:4] is reached.
7
CTS flow control enable bit
0 = Normal operation
1 = CTS flow control is enabled i.e., transmission is halted when a high signal is detected on the CTS pin.
divisor latches (DLL, DLH)
These are two 8-bit registers which store the 16-bit divisor for generation of the baud clock in the baud rate
generator. DLH, stores the most significant part of the divisor. DLL stores the least significant part of the division.
Note that DLL and DLH can only be written to before sleep mode is enabled (i.e., before IER[4] is set).
transmission control register (TCR)
This 8-bit register is used to store the receive FIFO threshold levels to start/stop transmission during
hardware/software flow control. Table 18 shows transmission control register bit settings.
30
POST OFFICE BOX 655303 • DALLAS, TEXAS 75265
TI [ TEXAS INSTRUMENTS ]
